American International PG10*50-130-2NV or 2PV Manual Do Utilizador

Página de 32
3
INSTALLATION INSTRUCTIONS
Consumer Information
OBSERVE ALL GOVERNING CODES AND ORDINANCES.
This water heater is design-certified by CSA International 
as a Category IV, direct vented water heater which takes 
its combustion air from the outside of the structure and 
exhausts all products of combustion to the outside of the 
structure.
This water heater must be installed according to all local 
and state codes or in the absence of local and state codes 
with the “National Fuel Gas Code”, ANSI Z223.1(NFPA 
54)- latest edition. Canadian installations must be per-
formed in accordance with CAN/CGA-B149. This is avail-
able from the following:
CSA America, Inc.
8501 East Pleasant Valley Road
Cleveland, OH 44131
National Fire Protection Agency
1 Batterymarch Park
Quincy, MA 02169-7471
Canadian Standards Association
178 Rexdale Boulevard
Toronto, ON M9W 1R3
Check the phone listings for the local authorities having 
jurisdiction over this installation.
Installer and Owner Responsibilities
This manual has been prepared to acquaint you with the 
installation, operation, and maintenance of your gas water 
heater and provide important safety information in these 
areas. 
Read all of the instructions thoroughly before attempting 
the installation or operation of this water heater. 
Do not discard this manual. You or future users of this 
water heater will need it for future reference.
Service to the water heater should only be performed 
by a qualified service technician.
Examples of qualified service technicians include: 
those trained in the plumbing and heating industry, 
local gas utility personnel, or an authorized service 
person.
The manufacturer and seller of this water heater will 
not be liable for any damages, injuries, or deaths 
caused by failure to comply with the installation and 
operating instructions outlined in this manual. 
If you lack the necessary skills required to properly install 
this water heater, or you have difficulty following the 
instructions, you should not proceed but have a qualified 
service technician perform the installation of this water 
heater.
Massachusetts code requires this water heater to be 
installed in accordance with Massachusetts Plumbing and 
Fuel Gas Code 248 CMR section 2.00 and 5.00. 
A data plate identifying your water heater can be found on 
the front of the heater. When referring to your water heater, 
always have the information listed on the data plate readily 
available. 
Retain your original receipt as proof of purchase.
Unpacking the Water Heater
Removing Packaging Materials
Important: Do not remove any permanent instructions, 
labels, or the data plate from outside of the water heater or 
on the inside of panels.
 
Remove exterior packaging and place installation  
components aside.
 
Inspect all parts for damage prior to installation and 
start-up.
 
Completely read all instructions before attempting to 
assemble and install this product.
 
After installation, dispose of packaging material in the 
proper manner.
Excessive Weight Hazard
Use two or more people to move and 
install water heater unless proper 
handling equipment is utilized.
Failure to do so can result in back or 
other injury.