Franklin 5870206300 Manual Do Utilizador

1.  Disconnect electrical power at the main breaker.

2.  Drain the system (if applicable).

3.  Install the pressure sensor and pressure shut-off sensor at the 

pressure tank tee downstream of the pressure tank (the pressure 
tank should be between the pressure sensor and the pump). The 
sensors have a ¼-18 National Pipe Thread (NPT) connection.

 

The pressure sensors should not be installed in an inverted 
orientation (up-side down). Make sure the pressure sensor and tank 
are not located more than 3 feet off the main piping.

4.  Install the unit to the wall using four mounting screws (not included) as 

shown in Figure 1 below. Remove the SubDrive lid by removing the eight 
lid screws.

Mounting Screw Locations 

(User Supplied Quantity 4)

Lid Screws (Included Quantity 8)