ONKYO CR-N7 Manual Do Utilizador

44

The ACCUCLOCK function normally uses the FM station with the strongest signal to set the clock. If the clock cannot 
be set properly using that station, you can specify which FM station the ACCUCLOCK function should use. This must 
be an FM station that supports RDS CT (Clock Time) information.

Tip:
You can also perform the operation by using the TIMER, ENTER, 

/

, and YES/MODE buttons on the remote 

controller.

Press TIMER.
“Clock” appears on the display.
If the clock has already been set, a timer option appears instead. In this case, you’ll need to 
press TIMER repeatedly until “Clock” appears.

Press MULTI JOG.
“*AccuClock*” or “AccuClock” appears on the display. If “Manual Adjust” appears, turn 
MULTI JOG to select “*AccuClock*” or “AccuClock”.

Press MULTI JOG.
The display appears as shown.

Tip:
If you press YES/MODE instead of using 

/

, the unit starts to search appropriate fre-

quency automatically.
The RDS indicator appears when tuned into a station that supports RDS, as shown.

Press MULTI JOG.
While the clock is being set, “Wait” flashes on the display. It may take a few minutes to set the 
clock. When the clock has been set, the message “Clock Adjusted” scrolls across the display, 
then the day and time are displayed for a while.

Notes:
• If the clock has not been set correctly, specify another FM station and try again, or set the 

clock manually (page 45).

• If you don’t want the clock to be updated automatically, you can turn off the ACCUCLOCK 

function (page 21).