Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Roland
  4. Fantom-X8
  5. Manual Do Utilizador

Roland Fantom-X8 Manual Do Utilizador

Download
Página de 348
 
241
Installing the Wave Expansion Board
 
fig.30-004
 
3.
 
There are four slots inside. As shown in the following 
illustration, plug the connector of the Wave Expansion 
Board into the connector of the relevant slot, and at the 
same time insert the board holder through the hole of the 
Wave Expansion Board.
 
fig.30-005.e
 
If you install expansion boards of the same type, only one board 
will be detected.
 
4.
 
Use the Installation Tool supplied with the Wave Expansion 
Board to turn the holders in the LOCK direction, so the 
board will be fastened in place.
 
fig.30-006.e
 
5.
 
Use the screws that you removed in step 2 to fasten the 
cover back in place.
 
After installation of the Wave Expansion Boards has been 
completed, check to confirm that the installed boards are being 
recognized correctly.
 
1.
 
 
2.
 
Press [MENU] to open the Menu window.
 
3.
 
Press 
 or 
 to select “System,” and then press 
[ENTER].
 
4.
 
Press [F4 (System Info)].
 
5.
 
Press [F1 (
 
⇑
 
)] or [F2 (
 
⇓
 
)] to select “SRX Info.”
 
The System screen appears. Verify that the name of the installed 
Wave Expansion Board is displayed.
 
fig.30-007_50
 
If an indication of “NOT INSTALLED” appears for a slot in 
which you installed a wave expansion board, it is possible that 
the board is not being recognized correctly. Re-install the Wave 
Expansion Board correctly.
 
6.
 
Press [EXIT] to exit the System Menu screen.
Board holder
Position them as shown 
before you install the board.
Connector
Wave Expansion Board (SRX series)
Installation tool
LOCK
 
Checking the Installed Wave 
Expansion Boards
Fantom-X678_r_e.book 241 ページ ２００５年５月１２日　木曜日　午後４時４０分