Roland Fantom-X8 Manual Do Utilizador

 

The Fantom-X comes with 32 MB of memory into which audio 
samples can be loaded. However, in some cases, 32 MB of memory 
will be insufficient for loading large amounts of data. In such a case, 
you will have to add separately sold memory (DIMM). Memory can 
be expanded up to 64/128/256/512 MB.

Before expanding the memory, consult with your retailer, the nearest 
Roland Service Center, or an authorized Roland distributor.

 

901

 

• To avoid the risk of damage to internal components that can be 

caused by static electricity, please carefully observe the 
following whenever you handle the board.

 

1

 

• Before you touch the board, always first grasp a metal object 

(such as a water pipe), so you are sure that any static electricity 
you might have been carrying has been discharged.

 

2

 

• When handling the board, grasp it only by its edges. Avoid 

touching any of the electronic components or connectors.

 

5

 

• Save the bag in which the board was originally shipped, and 

put the board back into it whenever you need to store or 
transport it.

• Use a Phillips screwdriver that is suitable for the size of the 

screw (a number 2 screwdriver, Fantom-X6/X7 only). If an 
unsuitable screwdriver is used, the head of the screw may be 
stripped.

• To remove a screw, rotate the screwdriver counter-clockwise. 

To tighten the screws, rotate the screwdriver clockwise.

• Be careful that the screws you remove do not drop into the 

interior of the Fantom-X.

• Be careful not to cut your hand on the edge of the cover or the 

opening edge while removing the cover.

• Do not touch any of the printed circuit pathways or connection 

terminals.

 

• Never use excessive force when installing a circuit board. If it doesn’t 

fit properly on the first attempt, remove the board and try again.

 

• When circuit board installation is complete, double-check your 

work.

• Always turn the unit off and unplug the power cord before 

attempting installation of the memory DIMM board.

• Install only the specified memory DIMM board. Remove only 

the specified screws.

• When turning the unit upside-down, get a bunch of newspapers 

or magazines, and place them under the four corners or at both 
ends to prevent damage to the buttons and controls. Also, you 
should try to orient the unit so no buttons or controls get 
damaged.

• When turning the unit upside-down, handle with care to avoid 

dropping it, or allowing it to fall or tip over.

• Do not leave the bottom cover removed. After installation of the 

memory module is complete, be sure to replace the cover.

Install the memory module after removing the bottom panel cover.

 

fig.30-002.e

fig.30-003.e

fig.31-002

 

fig.31-003

tighten

loosen

Screws to be removed

Fantom-X6/X7 : bottom

Clé hexagonale 5 mm

Fantom-X8 : Panneau avant

Vis à enlever

Fantom-X678_r_e.book 244 ページ ２００５年５月１２日　木曜日　午後４時４０分