Roland Fantom-X8 Manual Do Utilizador

Creating a Rhythm Set

Wave Fine Tune

Adjusts the pitch of the waveform’s sound up or down in 1-cent
steps (+/-50 cents).

Value:

-50– +50

One cent is 1/100th of a semitone.

The Fine Tune of the entire rhythm tone is set by the Tone Fine
Tune parameter (p. 91).

Wave Level

You can set the volume of the waveform.

Value:

0–127

The volume level of each rhythm tone is set with the Tone Level
parameter; the volume levels of the entire rhythm set is set with
the Rhythm Level parameter (p. 87).

Wave Pan

This specifies the pan of the waveform. “L64” is far left, “0” is center,
and “63R” is far right.

Value:

L63–0–63R

Wave Rnd Pan Sw
(Wave Random Pan Switch)

Use this setting to cause the waveform’s panning to change
randomly each time a key is pressed (ON) or not (OFF).

Value:

OFF, ON

The range of the panning change is set by the Rnd Pan Depth
parameter (p. 94).

WMT Velocity Control (Velocity Control Switch)

WMT Velocity Control determines whether a different rhythm tone
is played (ON) or not (OFF) depending on the force with which the
key is played (velocity).

When set to “RND,” the rhythm set’s constituent rhythm tones will
sound randomly, regardless of any Velocity messages.

Value:

OFF, ON, RANDOM

Wave Alter Pan Sw
(Wave Alternate Pan Switch)

This setting causes panning of the waveform to be alternated
between left and right each time a key is pressed. Set Alternate Pan
Switch to “ON” to pan the Wave according to the Alter Pan Depth
parameter (p. 94) settings, or to “REV” when you want the panning
reversed. If you do not want the panning to change each time a key
is pressed, set this to “OFF.”

Range:

OFF, ON, REV

Velo Fade Lower (Velocity Fade Width Lower)

This determines what will happen to the tone’s level when the tone
is played at a velocity lower than its specified velocity range. Higher
settings produce a more gradual change in volume. If you want
notes played outside the specified key velocity range to not be
sounded at all, set this to “0.”

Value:

0–127

Velo Range Lower (Velocity Range Lower)

This sets the lowest velocity at which the waveform will sound.
Make these settings when you want different waveforms to sound in
response to notes played at different strengths.

Value:

1–UPPER

Velo Range Upper (Velocity Range Upper)

This sets the highest velocity at which the waveform will sound.
Make these settings when you want different waveforms to sound in
response to notes played at different strengths.

Value:

LOWER–127

If you attempt to set the Lower velocity limit above the Upper,
or the Upper below the Lower, the other value will
automatically be adjusted to the same setting.

Velo Fade Upper (Velocity Fade Width Upper)

This determines what will happen to the tone’s level when the tone
is played at a velocity greater than its specified velocity range.
Higher settings produce a more gradual change in volume. If you
want notes played outside the specified key velocity range to not be
sounded at all, set this to “0.”

Value:

0–127

fig.06-028.e

fig.07-011_50

For details on these settings, refer to

“How to make Rhythm

Set settings”

(p. 83).

Modifying Pitch (Pitch/Pitch Env)

Range Lower

Range Upper

Fade Lower