Aiwa CDC-Z137 Manual Do Utilizador
ENGLISH
2
ENGLISH
2
BASIC OPERATION,
AUDIO AND CLOCK
ADJUSTMENT
AUDIO AND CLOCK
ADJUSTMENT
PWR/ATT
SEL
DSPL
TU (TUNER)
Jog dial (PUSH-SOURCE)
+/–
Turning the unit on/off
• Press PWR/ATT to turn on the unit. The unit also turns
on when you insert a CD.
• Press and hold PWR/ATT until the unit turns off.
Note
Most operations described in this manual require the
unit to be turned on before starting the operation,
unless explicitly stated otherwise.
unit to be turned on before starting the operation,
unless explicitly stated otherwise.
Changing the source mode
1
Press Jog dial (PUSH-SOURCE).
Pressing Jog dial (PUSH-SOURCE) cycles through
source modes in the following order:
Pressing Jog dial (PUSH-SOURCE) cycles through
source modes in the following order:
TUNER (FM1/FM2/FM3/AM1/AM2)
→ CD* → AUX
↑
* “CD” does not appear in the display when there is no
CD in the unit.
Adjusting the volume
1
Turn Jog dial.
VOLUME indicator appears.
VOLUME indicator appears.
Muting the sound
1
Press PWR/ATT briefly.
ATT indicator flashes.
ATT indicator flashes.
To restore volume, briefly press PWR/ATT again.
Adjusting sound
You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).
1
Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode’s indicator appears.
adjusted.
Pressing SEL cycles through the modes. The
selected mode’s indicator appears.
2
Turn Jog dial to increase/decrease the level or to
select on/off for the selected mode.
select on/off for the selected mode.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.
selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode’s
volume to almost the same level.
mode. In this case, you can align each source mode’s
volume to almost the same level.
1
Press Jog dial (PUSH-SOURCE) or TU (TUNER)
repeatedly to select the desired mode.
repeatedly to select the desired mode.
2
Press DSPL while pressing SEL.
“LA 0” appears on the display.
“LA 0” appears on the display.
3
Turn Jog dial to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
will be canceled.
Restoring the factory settings
1
Turn off the unit.
2
Press and hold DSPL until “LA --” appears on the
display.
display.
Note
You can restore the factory settings only for VOL,
BASS, TRE, BAL, FAD, and H-BASS, and aligned
source volume levels.
BASS, TRE, BAL, FAD, and H-BASS, and aligned
source volume levels.
Setting the beep tone
1
Turn off the unit.
2
Press and hold SEL until “bEEP” appears on the
display.
display.
3
Turn Jog dial to select on (level indicators appear)
or off (level indicators disappear).
or off (level indicators disappear).
4
Press SEL.