Eureka 6820 Manual Do Utilizador

Página de 5
 
DO NOT OIL the motor or the brush roll. The 
motor and brush roll are permanently sealed 
and lubricated.
To reduce the risk of fire, electric shock, or injury :
  Do not use outdoors or on wet surfaces.
  Do not leave vacuum cleaner when plugged in. Turn off 
the switch and unplug the electrical cord when not in use 
and before servicing.
  Do  not  allow  to  be  used  as  a  toy.  Close  attention  is 
necessary when used by or near children.
  Use  only  as  described  in  this  manual.  Use  only 
manufacturerʼs recommended attachments.
•  Do not use with damaged cord or plug. If vacuum cleaner 
is not working as it should, has been dropped, damaged, 
left outdoors, or dropped into water, return it to a service 
center before using.
  Do not pull or carry by cord, use cord as a handle, close 
door on cord, or pull cord around sharp edges or corners. 
Do not run vacuum cleaner over cord. Keep cord away 
from heated surfaces.
•  Hold plug when rewinding onto cord reel. Do not allow plug 
to whip when rewinding.
  Do  not  use extension  cords  or  outlets  with  inadequate 
current carrying capacity.
2
•  Turn off all controls before unplugging.
•  Do not unplug by pulling on cord. To unplug, grasp the 
plug, not the cord.
•  Do not handle plug or vacuum cleaner with wet hands or 
operate without shoes.
•  Do not put any object into openings. Do not use with any 
opening blocked; keep free of dust, lint, hair, and anything 
that may reduce airflow.
•  This  vacuum  cleaner  creates  suction  and  contains  a 
revolving brush roll. Keep hair, loose clothing, fingers, and 
all parts of body away from openings and moving parts.
•  Do not pick up anything that is burning or smoking, such 
as cigarettes, matches, or hot ashes.
•  Do not use without dust bag or filter in place.
•  Use extra care when cleaning on stairs.
•  Do not use to pick up flammable or combustible liquids such 
as gasoline, or use in areas where they may be present.
•  Store your cleaner indoors in a cool, dry area.
•  Keep your work area well lighted.
•  Unplug electrical appliances before vacuuming them.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
SAVE THESE INSTRUCTIONS
To reduce the risk of electric shock, this appliance has a 
polarized plug (one blade is wider than the other). This plug 
will fit in a polarized outlet only one way. If the plug does not 
fit fully into the outlet, reverse the plug. If it still does not fit, 
contact a qualified electrician to install the proper outlet. Do 
not change the plug in any way.
GENERAL INFORMATION
Use  the  cleaner  to  pick  up  dirt  and  dust  particles. Avoid 
picking  up  hard  or  sharp  objects  that  could  damage  the 
vacuum cleaner.
Service Information
The instructions in this booklet serve as a guide to routine 
maintenance. For additional service information, telephone 
our  toll  free  number  for  the  nearest  Eureka Authorized 
Warranty Station. You should know the model, type and 
serial number or date code when you call :
USA : 1-800-282-2886     Mexico :  5670-6169     
Canada : 1-800-282-2886
If you prefer, you can write to The Eureka Company, Service 
Division, 807 North Main St., Bloomington, Illinois 61701, 
USA. In Canada, write to The Eureka Company, 866 Langs 
Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka 
Warranty for complete service information.
Automatic Motor Shut-Off
To  protect  from  overheating,  this  vacuum  cleaner  is 
equipped  with  a  thermostat  which  automatically  shuts  off 
the motor if it overheats. Should this happen:
1. Turn off the switch and unplug the cleaner because 
the  thermostat  will  allow  the  cleaner  to  automatically 
start running again when the motor cools (approximately 
30 minutes).
2. Check the hose, bag and filter regularly, as a clogged 
hose,  full  bag  or  dirty  filter  could  cause  the  motor  to 
overheat.
3. Call  a  Eureka  Service  Station  if  the  cleaner  will  not 
operate after cooling for approximately 30 minutes.