Yamaha RX-SL100RDS Manual Do Utilizador
10
SPEAKER SETUP
■
IMPEDANCE SELECTOR switch
Do not change the setting of the IMPEDANCE
SELECTOR switch when the unit power is switched on,
as doing so may damage the unit.
SELECTOR switch when the unit power is switched on,
as doing so may damage the unit.
If this unit fails to turn on when STANDBY/ON is pressed
on either the front panel or remote control, the
IMPEDANCE SELECTOR switch may not be fully slid to
either position. If this is the case, slide the switch all the
way to either position when this unit is in standby mode.
Be sure to move this switch only when this unit is in
standby mode.
Select the switch position (top or bottom) according to the
impedance of the speakers in your system.
on either the front panel or remote control, the
IMPEDANCE SELECTOR switch may not be fully slid to
either position. If this is the case, slide the switch all the
way to either position when this unit is in standby mode.
Be sure to move this switch only when this unit is in
standby mode.
Select the switch position (top or bottom) according to the
impedance of the speakers in your system.
Switch
position
Speaker
Impedance level
Top
Front
The impedance of each speaker
must be 4
must be 4
Ω
or higher.
Center, Surround
back, Surround
Bottom
Front
The impedance of each speaker
must be 6
must be 6
Ω
or higher.
Center, Surround
back, Surround
CAUTION
MAINS
IMPEDANCE SELECTOR switch
01EN.00_RX-SL100RDS.book Page 10 Thursday, November 27, 2003 12:42 PM