Yamaha RX-V3800 Manual Do Utilizador

B

“NG” appears in the display window (B) on the 
remote control if learning was unsuccessful. In this 
case, start over from step 4.

y
• If you want to program another function, repeat steps 4 

and 5.

• If you continuously want to program another function for 

another component, press B

k / n to select the 

component, and then repeat steps 4 and 5.

M

LEARN

• “ERROR” appears in the display window (B) on the remote 

control if you press a button not indicated in the respective step, 
or when you press more than one button simultaneously.

• This remote control can learn approximately 200 functions. 

However, depending on the signals learned, “FULL” may 
appear in the display before you program 200 functions. In this 
case, clear unnecessary programmed functions to make room 
for further learning.

• Learning may not be possible in the following cases:

– when the batteries in the remote control for this unit or other 

components are weak.

– when the distance between the two remote controls is too 

great or too small.

– when the remote control infrared windows are not facing each 

other at the appropriate angle.

– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or 

uncommon.

You can change the name of the input source that appears 
in the display window (B) on the remote control if you 
want to use a different name from the factory preset. This 
feature is useful when you have set an input area to control 
a different component.

D

AMP

D

SOURCE

1

The name of the selected input area appears in the 
display window (B).

M

RENAME

If you do not complete each of the following steps within 30 
seconds, the renaming mode will be automatically canceled. 
In this case, start over from step 2.