Yamaha RX-495RDS Manual Do Utilizador

●

VOLUME, BASS, TREBLE, BALANCE, LOUDNESS
controls and PURE DIRECT switch settings have no effect
on the material being recorded.

●

To dub from tape to tape, select TAPE 2 by pressing it.
Only the following method of dubbing can be made by using
this unit.

Select the source to be recorded.

*

When you select AUX, TUNER, CD or PHONO, make
sure that TAPE MONITOR is not also selected.

Play the source and then turn the VOLUME control up
to confirm the input source.  (For detailed information
on the tuning operations, refer to the page 17.)

Begin recording on the tape deck.

To monitor the audio signals being recorded, press the
TAPE MONITOR.

15

Select the source to be recorded.

*

To dub from tape to tape, refer to the “Notes” shown
below.

*

When you select AUX, TUNER, CD or PHONO, make
sure that neither TAPE 1 nor TAPE 2 is also selected.

Play the source and then turn the VOLUME control up
to confirm the input source.  (For detailed information
on the tuning operations, refer to the page 17.)

Begin recording on the tape deck.

To monitor the audio signals being recorded, press the
input selector button for the tape deck being used to
make the recording.

Note
VOLUME, BASS, TREBLE, BALANCE and LOUDNESS
control settings have no effect on the material being recorded.

SOURCE

Tape deck connected to

the TAPE 2 terminals.

RECORDER

Tape deck connected to

the TAPE 1 terminals.

→