Yamaha RX-V561 Manual Do Utilizador
27
En
Optimizing the speaker setting for your listening room
English
PRE
P
ARA
T
ION
■ If an error screen appears
Press Gk / n / l / h to select “RETRY” or
“EXIT” and then press G
“EXIT” and then press G
ENTER.
The following display is an example where “E-5:USER
CANCEL” appears in the OSD.
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
• Select “RETRY” to retry the “AUTO SETUP”
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
■ If “WARNING” appears
When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” appears in the
“RESULT:EXIT” display. Check the warning messages to
correct your speaker settings.
“AUTO SETUP” procedure, “WARNING” appears in the
“RESULT:EXIT” display. Check the warning messages to
correct your speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press G
“WARNING” and then press G
ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2
Press
Gl / h repeatedly to toggle between
the warning displays.
y
• For details about each warning message, see the “AUTO
• For details about each warning message, see the “AUTO
SETUP” section in “Troubleshooting” on page 65.
• When the corresponding warning message is not
applicable to a speaker, “–
–” is displayed instead.
3
Press G
ENTER to return to the top
“RESULT:EXIT” display.
AUTO:ERROR
. E-5:USER CANCEL
Don't operate
any function
any function
RETRY
EXIT
[ ]/[ ]:Select
[ENTER]:Return
[ENTER]:Return
>
Note
AUTO:RESULT
. WARNING(1)
RESULT
SP
:
3/2/0.1
DIST:
3.2/3.5m
LVL :
-2/+2dB
SET
CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
[ENTER]:Enter
>
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
--
Reverse Channel
--
FR
CENTER
--
--
--
[
p]/[[]:Select
[ENTER]:Return