Yamaha RX-V1600 Manual Do Utilizador

Setting remote control AMP codes
Select one of the following codes to set the remote control 
AMP code for the component you want to use.
Set AMP/SOURCE/TV to AMP or SOURCE and then 
change the remote control code settings.

• You need to set the corresponding remote control AMP ID 

(see page 91).

• When using multiple YAMAHA receivers/amplifiers, you 

may be able to operate the other components 
simultaneously with the default code setting. In this case, 
set one of the alternative codes to operate this unit 
separately.

Setting remote control tuner codes
Select one of the following codes to set the remote control 
tuner code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press TUNER 
on the remote control to select TUNER as the input source 
and then change the remote control code settings.

• You need to set the corresponding remote control tuner ID 

(see page 91).

• When using multiple YAMAHA receivers/amplifiers, you 

may be able to operate the other components 
simultaneously with the default code setting. In this case, 
set one of the alternative codes to operate this unit 
separately.

Setting remote control XM codes
Select one of the following codes to set the remote control 
XM code for the component you want to use.
Set AMP/SOURCE/TV to SOURCE and press XM on the 
remote control to select XM as the input source and then 
change the remote control code settings.

• You need to set the corresponding remote control XM ID 

(see page 91).

• When using multiple YAMAHA receivers/amplifiers, you 

may be able to operate the other components 
simultaneously with the default code setting. In this case, 
set one of the alternative codes to operate this unit 
separately.

Press ENTER.
The four-digit code set for the selected component 
appears in the display window.

0000 appears in the display window if no code has been set.

Press the numeric buttons to enter the 
four-digit remote control code for the 
component you want to use.
For a complete list of available remote control codes, 
refer to “LIST OF REMOTE CONTROL CODES” at 
the end of this manual.

Press ENTER to set the number.
OK appears in the display window if setting was 
successful.
NG appears in the display window if the setting was 
unsuccessful. In this case, start over from step 3.

y

If you continuously want to set up another code for another 
component, press the input selector button or 
SELECT k / n to select the component, then repeat steps 4 
through 6.

2001

(initial setting)

To operate this unit using 
the default code. 
To operate Zone 2 or Zone 3 
features (see page 104).

ID1 

(initial setting)

2002

To operate this unit using an 
alternative code. 
To operate Zone 2 or Zone 3 
features (see page 104).

ID2

2602 

(initial setting)

To operate this unit using 
the default code.

ID1 

(initial setting)

2603

To operate this unit using an 
alternative code.

ID2

2604 

(initial setting)

To operate this unit using 
the default code.

ID1 

(initial setting)

2605

To operate this unit using an 
alternative code.

ID2

+10