Yamaha RX-V861 Manual Do Utilizador

• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “W-1” appears, corrections are made, but they may not be optimal.
• If a warning message “W-2” or “W-3” appears, no corrections are made.
• If an error message “E-10” occurs repeatedly, contact a qualified Yamaha service center.

E-1:NO FRONT SP

Front L/R channel signals are not detected.

Check the front L/R speaker connections.

E-2:NO SUR SP

A surround channel signal is not detected.

Check the surround speaker connections.

E-3:NO PRNS SP

A presence channel signal is not detected.

Check the presence speaker connections.

E-4:SBR->SBL

Only a right surround back channel signal is 
detected.

Connect the surround back speaker to the 
LEFT SURROUND BACK SPEAKERS 
terminal if you only have one surround 
back speaker.

E-5:NOISY

Background noise is too loud.

Try running “AUTO SETUP” in a quiet 
environment.

—

Turn off noisy electric equipment like air 
conditioners or move them away from the 
optimizer microphone.

—

E-6:CHECK SUR.

Surround back speakers are connected, 
though surround L/R speakers are not.

Connect surround speakers when you use 
surround back speakers.

E-7:NO MIC

The optimizer microphone was unplugged 
during the “AUTO SETUP” procedure.

Connect the supplied optimizer microphone 
to the OPTIMIZER MIC jack on the front 
panel.

E-8:NO SIGNAL

The optimizer microphone does not detect 
test tones.

Check the microphone setting.

Check the speaker connections and 
placement.

E-9:USER CANCEL

The “AUTO SETUP” procedure was 
cancelled due to user activity.

Run “AUTO SETUP” again. 

E-10:INTERNAL ERROR

An internal error occurred.

Run “AUTO SETUP” again.

W-1:OUT OF PHASE

Speaker polarity is not correct. This 
message may appear depending on the 
speakers even when the speakers are 
connected correctly.

Check the speaker connections for proper 
polarity (+ or –).

W-2:OVER 24m (80ft)

The distance between the speaker and the 
listening position is over 24 m (80 ft).

Bring the speaker closer to the listening 
position.

—

W-3:LEVEL ERROR

The difference of volume level among 
speakers is excessive.

Readjust the speaker installation so that all 
speakers are set in locations with similar 
conditions.

—

Check the speaker connections.

Use speakers of similar quality.

—

Adjust the output volume of the subwoofer.

W-4:CHECK PRNS

“EXTRA SP ASSIGN” is set to 
“PRESENCE”, though the presence 
channel signals are not detected.

Check the presence speaker connections.

Set “EXTRA SP ASSIGN” to a setting 
other than “PRESENCE”.