Yamaha X-V2600 Manual Do Utilizador
16
CONNECTIONS
1
Remove approximately 10 mm (3/8 in) of
insulation from each of the speaker cables.
insulation from each of the speaker cables.
2
Twist the exposed wires of the cable together
to prevent short circuits.
to prevent short circuits.
3
Loosen the knob using the supplied speaker
terminal wrench.
terminal wrench.
4
Insert one bare wire into the hole on the side
of each terminal.
of each terminal.
5
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
supplied speaker terminal wrench.
6
Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
WRENCH HOLDER on the rear panel of this
unit when not in use.
10 mm (3/8 in)
Red: positive (+)
Black: negative (–)
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Speaker terminal wrench