Yamaha RXV3000 Manual Do Utilizador

18

■

Select the position whose requirements your speaker system meets.

 (Upper position)

The impedance of each speaker must be 6

Ω

 or higher.

The impedance of each speaker must be 4

Ω

 or higher.

REAR CENTER: The impedance of the speaker must be 4

Ω

 or higher.

The impedance of each speaker must be 6

Ω

 or higher.

REAR CENTER: The impedance of the speaker must be 6

Ω

 or higher.

CENTER: The impedance of the speaker must be 4

Ω

 or higher.

If you use one pair of main speakers, the impedance of each speaker
must be 4

Ω

 or higher.

If you use two pairs of main speakers, the impedance of each speaker
must be 8

Ω

 or higher.

 (Lower position)

The impedance of each speaker must be 8

Ω

 or higher.

The impedance of each speaker must be 8

Ω

 or higher.

The impedance of the speaker must be 8

Ω

 or higher.

CENTER: The impedance of the speaker must be 8

Ω

 or higher.

<Except for Canada model>
If you use one pair of main speakers, the impedance of each speaker
must be 8

Ω

 or higher.

If you use two pairs of main speakers, the impedance of each speaker
must be 16

Ω

 or higher.

<For Canada model only>
The impedance of each speaker must be 8

Ω

 or higher.

■

Plug in this unit to a wall outlet when all connections are complete.

• Do not use other AC power cords than the one provided. (U.S.A., Canada, and Singapore

models only)

■

Use these to connect the power cords from your other components to this unit. The
power to the switched outlets is controlled by this unit’s 

(

 or 

 on the remote). These outlets will supply

power to any connected unit whenever this unit is turned on. The maximum power
(total power consumption of components) that can be connected to 

is 100 W.

■

The voltage selector on the rear panel of this unit must be set for your local main
voltage BEFORE plugging into the AC main supply.

Do not change the 

 switch setting while the power to

this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FAILS TO TURN ON
WHEN THE STANDBY/ON SWITCH IS
PRESSED:
The 

 switch may

not be set to either end. If so, set the switch to
either end when this unit is in the standby
mode.

G.

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

Ω

AC OUTLETS

VOLTAGE SELECTOR
(General and China models)

AC Power Cord

(General, China, and Australia models)

IMPEDANCE SELECTOR switch

AC Power Cord

(U.S.A., Canada, and Singapore models only)