Yamaha HTR-6150 Manual Do Utilizador
23
En
Connections
English
PREP
ARA
TION
1
Press C
SYSTEM OFF on the front panel to
set this unit to the standby mode.
Refer to the right column for details.
Refer to the right column for details.
2
Press and hold N
TONE CONTROL and
then press A
MAIN ZONE ON/OFF to turn
on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Press O
PROGRAM l / h to select “SP
IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8
“SP IMP.” and the current speaker impedance setting
(“8
Ω MIN”) appear in the front panel display.
4
Press P
STRAIGHT repeatedly to select “6Ω
MIN”.
5
Press A
MAIN ZONE ON/OFF to save the
new setting and turn off this unit.
The setting you made is reflected next time you turn on this unit.
■ Turning on this unit
Press A
MAIN ZONE ON/OFF (or HPOWER)
to turn on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press A
MAIN ZONE ON/OFF (or
I
STANDBY) to set this unit to the standby
mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
y
You can set the main zone and zone 2 to the standby mode
simultaneously by pressing
simultaneously by pressing
CSYSTEM OFF.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6
If you are to use 6 ohm speakers, set “SP IMP.” to
“6
Ω MIN” as follows BEFORE using this unit.
Note
TONE CONTROL
ON/OFF
MAIN ZONE
While holding
down
Turning on and off the power
01EN_HTR-6150_UC.book Page 23 Friday, February 1, 2008 11:21 AM