JVC RX-772VBK Manual Do Utilizador

Page 28

DELAY 1

DELAY 2

DELAY 4

DELAY 3

Left front speaker

Center speaker

Rear speakers

Right front speaker

Front panel

SHARP1

SHARP2

FLAT

SOFT2

SOFT1

6. Press Control

% / fi

fi until “–DELAY +” appears on the display.

7. Press Control

@ / #

# to adjust the delay time of the rear speaker output.

Each time you press the button, the delay time changes as follows:

DELAY 1:

Select this when the distance from you to your rear speakers is greater than that to the front

speakers.

DELAY 2:

Select this when the distance from you to your rear speakers is almost equal to that to the

front speakers.

DELAY 3:

Select this when the distance from you to your rear speakers is a little less than that to the
front speakers.

DELAY 4:

Select this when the distance from you to your rear speakers is much less than that to the
front speakers.

Note:
When you have selected “3CHLOGIC,” you cannot adjust the delay time.

8. Press Control

% / fi

fi until “TEST” appears on the display, then press Control @

@ / #

# to start

checking the speaker output balance.
“TEST” starts flashing on the display, and a test tone comes out of the speakers in the following
order:

Notes:
• No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”
• No test tone comes out of the center speaker when you select “PHANTOM” or “OFF” for the center

mode.

9. If necessary, adjust the speaker output balance as follows:

• To adjust the rear speaker output level, press Control

% / fi until “– REAR +” appears on the

display, then press Control

@ / #.

• To adjust the center speaker output level, press Control

% / fi until “–CENTER+” appears on the

display, then press Control

@ / #.

Notes:
• You cannot adjust the left and right rear speakers output level separately.
• You cannot adjust the rear speakers output level when you have selected “3CHLOGIC.”
• You cannot adjust the center speaker output level when you select “PHANTOM” or “OFF” for the

center mode.

10. Press Control

% / fi

fi until “TEST” appears on the display, then press Control @

@ / #

# to stop the

test tone.

11. Press Control

% / fi

fi until “CNT TONE” (Center Tone) appears on the display.

12. Press Control

@ / #

# to select the center tone you want.

The center tone adjustment affects the mid-frequency range, which the human voice is mostly made
up of.
Each time you press the button, the display changes to show the following:

To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much).
To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much).
When “FLAT” is selected, no adjustment is applied.

Note:
The center tone cannot be adjusted when sounds do not come out of the center speaker.

RX-772VBK[J]_0052-001A.En.24-30

97.4.8, 3:25 PM