Kenwood VR-9080 Manual Do Utilizador

• No setup codes registered for the respective

input(s).

• The remote control unit is set to a different

operation mode.

• Batteries are exhausted.
• The remote control unit is too far away from

the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.

• No disc or tape is placed  in the source

component.

• An attempt is made to play a tape which is

being recorded in the cassette deck.

• The remote control has not been set to the

operation mode for the component you wish
to control.

• Register a setup code at the respective input(s).

w

• Press the RCV MODE key to select the

appropriate operation mode.

• Replace with new batteries.
• Operate the remote control unit within the

controllable range.

• Place the disc or tape in the source component

which you want to play.

• Wait until recording has completed.

• Press any of the Source keys or   SOURCE

key to activate the operation mode for the
component you want to control before
operation.

w

• No antenna is connected.
• The broadcast band is not set properly.
• The frequency of the desired station is not

tuned.

• Noise due to ignition noise from an automobile.

• Noise due to interference from an electric

appliance.

• Noise due to a nearby TV set.

• The preset station belongs to a frequency that

cannot be received.

• The preset memory was cleared because the

power cord had been unplugged for a long
period of time.

• Connect an antenna.

(

• Set the broadcast band properly.
• Tune the frequency of the desired station.

⁄

• Install the outdoor antenna away from the

road.

• Turn off the power to the appliance.

• Install the receiver farther away from the TV.

• Preset a station with a receivable frequency.

• Preset the station again.

*5557/42-56/EN

05.7.16, 1:30 PM

54