Kenwood KRF-V7300D Manual Do Utilizador
32
KRF-V9300D/KRF-V8300D/KRF-V7300D
Set
u
p
The Auto Room EQ function sets up the optimum home theater
environment by automatically measuring and analyzing the
following properties.
environment by automatically measuring and analyzing the
following properties.
¶ Connected speakers
¶ Distance from each speaker to the listening
position
¶ Size of each speaker
¶ Polarity of each speaker
¶ Reproduce frequency characteristic of each
speaker
¶ Volume level of each speaker
This function uses the setup microphone provided with this unit.
The speakers output high-level test tones during measurement.
Take special care for the neighborhood and sleeping children
when using this function particularly in the nighttime.
when using this function particularly in the nighttime.
AUTO ROOM EQ
MULTI CONTROL
//O/
//O/
ENTER
1
Connect the microphone to this unit.
L
R
AUX
CD
MD/TAPE
VIDEO1
ANTENNA
VIDEO2
AUDIO
DVD/6CH IN
FRONT SPEAKERS (6 – 16 )
AUTO ROOM EQ
MIC IN
MIC IN
VIDEO1 IN
VIDEO1 IN
MONITOR OUT
MONITOR OUT
DVD IN
DVD IN
VIDEO2 IN
VIDEO1 OUT
CD(ASSIGNABLE)
SUB WOOFER
PRE OUT
PRE OUT
VIDEO2
DVD
DVD
OPTICAL
CENTER
SURROUND
FRONT
PLAY IN
PLAY IN
REC OUT
PLAY IN
PLAY IN
PLAY IN
REC OUT
SUB WOOFER
OPTICAL COAXIAL
VIDEO2 IN
MONITOR OUT
HDMI
DIGITAL IN
S-VIDEO
VIDEO
COMPONENT VIDEO
+
‒
+
‒
RED
WHITE
GRAY
BLUE
GREEN
TAN
BROWN
AM
SPEAKER A
SPEAKER B
CENTER
SURROUND
SURROUND BACK
GND
FM 75
5V
500mA
iPod
Y
CB
CR
VIDEO2 IN
Y
CB
CR
L
R
L
R
L
R
L
R
SURROUND SPEAKERS (6 – 16 )
AUTO ROOM EQ
MIC IN
MIC IN
CENTER
SUB WOOFER
SUB WOOFER
PRE OUT
PRE OUT
If headphones are plugged in, unplug them.
2
Place the microphone in the listening position.
Place the microphone at the height of the listener’s ears.
Do not place any obstacle between the microphone and
the speakers.
the speakers.
3
Enter the Auto Setup mode and start
measurement.
[AUTO ROOM EQ]
Use [MULTI CONTROL
2/3] to select "Calibrate".
[ENTER]
Use [MULTI CONTROL
2/3] to select "Start".
[ENTER]
It takes about 2 minutes before the measurement
completes.
completes.
The display changes from "Calibrating 1" to "Calibrating 2".
When the measurement completes, the display changes
to "Analyzing", indicating that the measurement results are
being analyzed. In this case, go to step 6.
When the measurement completes, the display changes
to "Analyzing", indicating that the measurement results are
being analyzed. In this case, go to step 6.
If the measurement stopped in the middle and a message is
displayed, go to step 4.
displayed, go to step 4.
4
Check the message and take an action against the
message.
See <If a message is displayed>
› and check the
content of the message and follow the instructions.
KRF-V9300D and KRF-V8300D Speaker setup –"Auto Setup"(Auto Room EQ)–
B60-5740-00_00_EN.indd 32
B60-5740-00_00_EN.indd 32
08.7.17 3:29:54 PM
08.7.17 3:29:54 PM