Kenwood VRS-6100 Manual Do Utilizador

6

5

4

3

2

7

8

9

0

1

@

!

#

%

$

^

While the standby indicator is lit, a small amount of power is supplied to the system to back up the memory. This is called standby mode. Under the
condition, the system can be turned ON by the remote control unit.

1 POWER ON/STANDBY   key *

Use to turn the power ON/STANDBY.

Lights when the power is in the standby
mode.

2 DIMMER key

Use to select the REC MODE.

∞

Use to adjust the brightness of the display.

‹

3 INPUT MODE key

8

Use to switch between the full auto, digital and

analog input.

4 SOUND key

•

Use to adjust the sound quality and the ambi-

ence effects.

5 MEMORY key

§

Use to presetting of radio stations.

6 BAND key

§

Use to select the broadcast band.

7 AUTO/MONO key

§

Use to select the auto or manual tuning

mode.

8 Dolby D indicator

º

Lights when the receiver is in the Dolby

Digital mode.

º

Lights when the receiver is in the DTS mode.

 £

Lights when the LOUDNESS mode is ON.

9 MULTI CONTROL button

&

Use to control a variety of settings.

0 ACTIVE EQ key

£

Use to select ACTIVE EQ’s setting.

Speaker selection indicators,
Input channel indicators (The Input
channel indicators lights up to indicate
the channels contained in the input
signal.

 

The "S" indicator lights when the

surround component consists of a single
channel.)

ACTIVE EQ indicator,

96 kHz fs indicator

Frequency display,
Input display,
Preset channel display,
Listen mode display

MUTE indicator

CLIP indicator

Input mode indicators

Listen mode indicators

! VOLUME CONTROL knob

™

Use to adjust the receiver volume.

@ INPUT SELECTOR key

™

Use to select input sources.

# SETUP key

&

Use to select the speakers' settings etc.

$ LISTEN MODE key

º

Use to select the listening mode.

% FRONT AUX jacks

$

^ PHONES jack

¢

Use for headphone listening.

AUTO indicator,

 ST. indicator,

TUNED indicator, TONE indicator

View when the FRONT AUX  jack cover is open.

*5484/01-07/EN

04.5.17, 8:34 AM

6