ONKYO TX-SR8467 Manual Do Utilizador

39

1

Notes:
• Make sure the microphone is hori-

zontal.

• If there’s an obstacle between the 

microphone and any speaker, the 
automatic setup will not work cor-
rectly. Set up the room as you would 
when enjoying a DVD.

• Positioning the microphone close to 

where your ears would normally be 
will provide better results. You can 
adjust the height of the microphone 
by using a tripod or level table.

• It takes about 10 minutes to complete 

the automatic speaker setup.

Notes:
• If the AV receiver was previously 

muted, it will be unmuted.

• Automatic speaker setup cannot be 

performed while a pair of head-
phones is connected.

The automatic speaker setup starts.

A test tone is output by each speaker in 
turn, as the Audyssey2EQ function 
determines which speakers are con-
nected. This takes a few minutes.

Note:
If any extraneous noise is picked up by 
the microphone, the automatic setup 
may not work correctly, so don’t make 
any noise.

   Auto Speaker Setup
========================
Please place microphone
at center of listening
area at ear height.

   Push Enter:Next

   Auto Speaker Setup
========================
Do not unplug Setup Mic.

   Please, keep quiet.

     Now measuring...

“Yes” means that the speaker was 
detected. “No” means that no speaker 
was detected.

The options are:
Next: 

Proceed to the next step.

Retry: 

Return to step 2 and try again.

Cancel: 

Cancel the automatic speaker setup.

   Auto Speaker Setup
========================
----SP Detect Result----
    FL:Yes   FR:Yes
    SL:Yes   SR:Yes
   SBL:Yes  SBR:Yes
     C:No    SW:Yes
------------------------
  Next
  Retry
  Cancel