ONKYO TX-SR8460 Manual Do Utilizador

51

You can adjust the brightness of the display.

You can temporarily mute the output of the AV receiver.

With the sleep timer, you can set the AV receiver to turn 
off automatically after a specified period.

If you need to cancel the sleep timer, press the [SLEEP] 
button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver sleeps, 
press the [SLEEP] button. Note that if you press the 
[SLEEP] button while the sleep time is being displayed, 
you’ll shorten the sleep time by 10 minutes.

You can connect a pair of stereo headphones (1/4-inch 
phone plug) to the AV receiver’s PHONES jack for pri-
vate listening, as shown.

Notes:
• Always turn down the volume before connecting your 

headphones.

• The speakers are turned off while the headphones plug 

is inserted in the PHONES jack (Zone 2 speakers are 
not turned off).

• When you connect a pair of headphones, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio (not North American 
models). 

• Only the Stereo, Direct, Pure Audio (not North Amer-

ican models), and Mono listening modes can be used 
with headphones (the listening modes available also 
depend on the currently selected input source).

• When the multichannel input is used, only the front 

left and right audio can be heard in the headphones.

• To adjust the headphone level, press the [CH SEL] 

button on the remote controller, and then press the 
[LEVEL +]/[LEVEL -] buttons. You can adjust the 
level between –12 dB and +12 dB.

• Normal+VOLUME light on.
• Normal+VOLUME light off.
• Dim+VOLUME light off.
• Dimmer+VOLUME light off.

The output is muted and the MUTING 
indicator flashes on the display, as 
shown.

To unmute the AV receiver, press the 
[MUTING] button again, or adjust the 
volume.
The Mute function is cancelled when 
the AV receiver is set to Standby.

The sleep time can be set from 90 to 10 
minutes in 10 minute steps.

The SLEEP indicator appears on the 
display when the sleep timer has been 
set. The specified sleep time appears on 
the display for about five seconds, then 
the previous display reappears.