ONKYO TX-SR508 Manual Do Utilizador

En

• When Audyssey 2EQ Room Correction and Speaker Setup is 

complete, the “Audyssey” will be set to “On” (

38). The 

Audyssey indicator will light (

8). 

• You can cancel Audyssey 2EQ Room Correction and Speaker 

Setup at any point in this procedure simply by disconnecting the 
setup microphone.

• Do not connect or disconnect any speakers during 

Audyssey 2EQ Room Correction and Speaker Setup.

• If the AV receiver is muted, it will be unmuted automatically 

when Audyssey 2EQ Room Correction and Speaker Setup starts.

• Changes to the room after Audyssey 2EQ Room Correction and 

Speaker Setup requires you run Audyssey 2EQ Room Correc-
tion and Speaker Setup again, as room EQ characteristics may 
have changed.

While Audyssey 2EQ Room Correction and Speaker 
Setup is in progress, one of the error messages below may 
appear.

The options are:

`

Retry:

Try again.

`

Cancel:

Cancel Audyssey 2EQ Room Correction and 
Speaker Setup.

The background noise is too loud. Remove the source of 
the noise and try again.

The number of speakers detected was different from 
that of the first measurement. Check the speaker con-
nection.

This message appears if saving fails. Try saving again. 
If this message appears after 2 or 3 attempts, contact 
your Onkyo dealer.

This message appears if a speaker is not detected. “No” 
means that no speaker was detected.

• See “Speaker Configuration” for appropriate settings (

11).

You can manually make changes to the settings found dur-
ing Audyssey 2EQ Room Correction and Speaker Setup.
See also:
• “Sp Config (Speaker Configuration)” (

36)

• “Sp Distance (Speaker Distance)” (

• “Level Cal (Level Calibration)” (

If you’re using a powered subwoofer and it outputs very 
low-frequency sound at a low volume level, it may not be 
detected by Audyssey 2EQ Room Correction and Speaker 
Setup.
If the “Subwoofer” appears on the “Review Speaker 
Configuration” screen as “No”, increase the subwoofer’s 
volume to the half-way point, set it to its highest crossover 
frequency, and then try running Audyssey 2EQ Room 
Correction and Speaker Setup again. Note that if the vol-
ume is set too high and the sound distorts, detection issues 
may occur, so use an appropriate volume level. If the sub-
woofer has a low-pass filter switch, set it to Off or Direct. 
Refer to your subwoofer’s instruction manual for details.

Audyssey 2EQ

®

 performs more measurements. This 

takes a few minutes.

q/w to select an option, and then press 

The options are:

`

Save: 

Save the calculated settings and exit 
Audyssey 2EQ Room Correction and Speaker 
Setup.

`

Cancel: 

Cancel Audyssey 2EQ Room Correction and 
Speaker Setup.

• You can view the calculated settings for the speaker con-

figuration, speaker distances, and speaker levels by using 
e/r.

Error message