ONKYO TX-SR803/803E Manual Do Utilizador

83

Zone 2—Continued

If you’ve connected your Zone 2 speakers to this AV 
receiver, as explained in “Using Only Speakers in 
Zone 2” on page 82, you must set the “Powered Zone 2” 
setting to “Act” (Activated) as explained here.

Note:
• This procedure can also be performed on the AV 

receiver by using its [SETUP] button, arrow buttons, 
and [ENTER] button.

This section explains how to turn Zone 2 on and off, how 
to select an input source for Zone 2, and how to adjust 
the volume for Zone 2.

Press the [RECEIVER] REMOTE 
MODE button, followed by the 
[SETUP] button.
The main menu appears onscreen.

buttons to select “8. Hardware 
Setup,” and then press [ENTER].
The Hardware Setup menu appears.

Not Act: ZONE 2 SPEAKERS termi-
nals not activated.
Act: ZONE 2 SPEAKERS terminals 
activated.
When Act is selected and Zone 2 is 
turned on, the speakers connected to the 
ZONE 2 SPEAKERS terminals will 
output sound, but the speakers con-
nected to the SURROUND BACK 
SPEAKERS terminals will not. When 
Zone 2 is turned off, even if Act is 
selected, the surround back speakers 
will work as normal.

Press the [SETUP] button.
Setup closes.

RECEIVER

8.Hardware Setup
------------------------
 a.PoweredZone2:NotAct
 b.TV Format     :Auto
 c.AM Freq. Step: 9kHz
 d.Remote ID        :1

a.PoweredZone2:NotAct

Zone 2 turns on, the ZONE 2 indicator 
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).

To select AM, FM, or XM (North 
American model only), press the 
[TUNER] input selector button repeat-
edly.

To select the same source as that of the 
main room, press the [ZONE 2] button 
repeatedly until “Zone 2 Sel: Source” 
appears.