ONKYO tx-sr444 Manual Do Utilizador

Details on AM/FM reception

¼



1.  Press TUNER on the remote controller several times to 

select either "AM" or "FM".

2.  Press TUN MODE so that the "AUTO" indicator on the 

display lights.

3.  Press the cursors  /  to start automatic tuning.

● Alternatively you can press  TUNING  on the main 

unit to start tuning automatically.

● Searching automatically stops when a station is 

found. When tuned into a radio station, the  

" TUNED " indicator on the display lights. When 

tuned into an FM radio station, the "FM STEREO" 

indicator lights.

● No sound is output while the " TUNED " indicator 

is off.

When the signal from an FM radio station is weak: 

Radio wave may be weak depending on the building 

structure and environmental conditions. In that case, 

perform the procedure as explained below in "Tuning 

Manually" to manually select the desired station.

¼



1.  Press TUNER on the remote controller several times to 

select either "AM" or "FM".

2.  Press TUN MODE so that the "AUTO" indicator on the 

display goes off.

3.  While pressing the cursors  / , select the desired radio 

station.

● Alternatively you can press  TUNING  on the main 

unit.

● The frequency changes by 1 step each time 

you press the button. The frequency changes 

continuously if the button is held down and stops 

when the button is released. Tune by looking at the 

display.

To return to automatic tuning: Press TUN MODE on the 

remote controller again. The unit tunes automatically into a 

radio station. Normally "AUTO" should be displayed.

¼



It allows you to directly enter the frequency of the radio 

station you want to listen to.
1.  Press TUNER on the remote controller several times to 

select either "AM" or "FM".

2.  Press D.TUN.

3.  Using the number buttons, enter the frequency of the 

radio station within 8 seconds.

● To enter 87.5 (FM), for example, press 8, 7, 5, or 8, 

7, 5, 0. If you entered a wrong number, press D.TUN 

and enter a correct one.