ONKYO TX-SR501E Manual Do Utilizador

33

With this function you can temporarily mute the output of the 
TX-SR501/TX-SR501E.

Muting is cancelled when the TX-SR501/TX-SR501E is set 
to Standby.

With this function you can adjust the volume level of each 
individual speaker as you like. Unlike the individual speaker 
volume settings described on page 27, these adjustments can 
be carried out while listening to your favorite music, and they 
are temporary (i.e., they are not saved when the TX-SR501/
TX-SR501E is set to Standby), although you can save them 
if you want.

To cancel this function, press the [CH SEL] button repeat-
edly until the previous display appears.

To save your adjustments, updating the settings described on 
page 27, press the [TEST] button.

• You cannot use this function while the TX-SR501/TX-SR501E is 

• Only speakers that are included in the current configuration can 

• The subwoofer cannot be selected if the subwoofer mode is set to 

“Subwoofer Off” (page 25).

With the sleep timer you can set the TX-SR501/TX-SR501E 
so that it automatically turns off after a set period.

You can connect a pair of stereo headphones (1/4-inch phone 
plug) to the TX-SR501/TX-SR501E’s PHONES jack for pri-
vate listening, as shown.

Notes:
• Always turn down the volume before connecting your 

headphones.

• Speaker sets A and B are turned off while the headphones 

plug is inserted in the PHONES jack.

• When you connect a pair of headphones to the TX-SR501/

TX-SR501E, the listening mode is set to Stereo, unless it’s 
already set to Stereo or Direct. When you disconnect the 
headphones, the previous listening mode is selected.

• When you use the multi-channel inputs, only the front-left 

and front-right channels can be heard in the headphones.

The output is muted and the MUTING 
indicator flashes on the display, as shown.

The output is unmuted and the MUTING 
indicator goes off.

Speakers are selected in the following 
order: Left 

→

 Center 

→

 Right 

→

 Surr 

Right 

→

 Surr Back 

→

 Surr Left 

→

 Sub-

woofer.

You can adjust the volume of each 
speaker from –12 dB to +12 dB.

The name of the currently selected 
speaker and its volume appear on the dis-
play, as shown.

You can set the sleep time from 90 to 10 
minutes in 10 minute steps.

The SLEEP indicator appears on the dis-
play when the sleep timer has been set, as 
shown. The specified sleep time appears 
on the display for about five seconds, then 
the previous display reappears.

To cancel the sleep timer, press the 
[SLEEP] button repeatedly until the 
SLEEP indicator disappears.

To check the remaining sleep time, 
press the [SLEEP] button. Note that if you 
press the [SLEEP] button while the sleep 
time is being displayed, you’ll shorten the 
sleep time by 10 minutes.