ONKYO TX-SR501E Manual Do Utilizador

5

The Worldwide model has a voltage selector for compatibil-
ity with power systems around the world. Before you plug in 
this model, make sure that the voltage selector is set to the 
correct voltage for your area. If it isn’t, use a small screw-
driver to set it as appropriate. For example, if the voltage in 
your area is 120 volts (V), set the selector to “120V.” And if 
it’s between 220 and 230 volts (V), set it to “220–230V.”

Notes:
• The supplied batteries should last for about six months, 

although this will vary with usage.

• If the remote controller doesn’t work reliably, try replacing 

both batteries.

• Don’t mix new and old batteries, or different types of bat-

teries.

• If you intend not to use the remote controller for a long 

time, remove the batteries to prevent possible leakage and 
corrosion.

• Flat batteries should be removed as soon as possible to pre-

vent possible leakage and corrosion.

To use the remote controller, point it at the TX-SR501/
TX-SR501E’s remote control sensor, as shown below. The 
TX-SR501/TX-SR501E’s STANDBY indicator flashes 
while a signal is being received from the remote controller.

Notes:
• The remote controller may not work reliably if the 

TX-SR501/TX-SR501E is subjected to bright light, such 
as direct sunlight or inverter-type fluorescent lights. Keep 
this in mind when installing the TX-SR501/TX-SR501E.

• If another remote controller of the same type is used in the 

same room, or the TX-SR501/TX-SR501E is installed 
close to equipment that uses infrared rays, the remote con-
troller may not work reliably.

• Don’t put anything, such as a book, on the remote control-

ler, because the buttons may be pressed inadvertently, 
thereby draining the batteries.

• The remote controller may not work reliably if the 

TX-SR501/TX-SR501E is installed in a rack behind col-
ored glass doors. Keep this in mind when installing the 
TX-SR501/TX-SR501E.

• The remote controller will not work if there’s an obstacle 

between it and the TX-SR501/TX-SR501E’s remote con-
trol sensor.