ONKYO TX-SR707 Manual Do Utilizador

103

In addition to your main listening room, you can also enjoy playback in the other room, or as we call Zone 2. And, you 
can select a different source for each room.

There are two ways you can connect Zone 2 speakers:
1. Connect them directly to the AV receiver.
2. Connect them to an amp in Zone 2.

This setup allows 5.1-channel playback in your main 
room and 2-channel stereo playback in Zone 2, with a 
different source in each room. This is called Powered 
Zone 2, as the Zone 2 speakers are powered by the AV 
receiver. Note that when Powered Zone 2 is turned off, 
you can enjoy 7.1-channel playback in your main room.

Hookup
• Connect your Zone 2 speakers to the AV receiver’s 

SURR BACK/ZONE 2 L/R speaker terminals.

Notes:
• With this setup, the Zone 2 volume is controlled by the 

AV receiver.

• Powered Zone2 cannot be used if “Speakers 

Type(Front)” is set to “Bi-Amp” (see page 47).

This setup allows 7.1-channel playback in your main lis-
tening room and 2-channel stereo playback in Zone 2, 
with a different source in each room.

Hookup
• Use an RCA audio cable to connect the AV receiver’s 

ZONE 2 LINE OUT L/R jacks to an analog audio 
input on your Zone 2 amp.

• Connect your Zone 2 speakers to the speaker terminals 

on your Zone 2 amp.

Note:
The Zone 2 volume must be set on the Zone 2 amp.

When Zone 2 is turned on, the output from the 12V 
TRIGGER OUT ZONE 2 goes high (+12 volts, 150 mil-
liamperes max). Connecting this jack to a 12-volt trigger 
input on a component in Zone 2 will make that compo-
nent turn on or off as and when Zone 2 is turned on or off 
on the AV receiver.

To use this setup, you must set the “Powered Zone2” 
setting to “Act” (see page 104).

TV

AV receiver

TV

AV receiver

Receiver/

integrated amp

TX-SR707_En.book  Page 103  Tuesday, July 28, 2009  1:03 PM