ONKYO TX-SR707 Manual Do Utilizador

123

There’s no picture
• Make sure that all video connecting plugs are pushed 

in all the way (page 23).

• Make sure that each video component is properly con-

• If your TV is connected to the HDMI OUT, select 

“- - - - -” in the “HDMI Input Setup” on page 44 to 
watch composite video, S-Video, and component 
video sources.

• If the video source is connected to a component video 

input, you must assign that input to an input selector 
(page 45), and your TV must be connected to either 
the HDMI OUT or COMPONENT VIDEO MONI-
TOR OUT (pages 25 and 28).

• If the video source is connected to an S-Video or com-

posite video input, your TV must be connected to the 
HDMI OUT or the corresponding S-Video or compos-
ite video output (pages 25 and 28).

• If the video source is connected to an HDMI input, 

you must assign that input to an input selector 
(page 44), and your TV must be connected to the 
HDMI OUT (page 25).

• While the Pure Audio listening mode is selected, the 

video circuitry is turned off and only video signals 
input through HDMI IN can be output.

• On your TV, make sure that the video input to which 

the AV receiver is connected is selected.

There’s no picture from a source connected to 
an HDMI IN
• Reliable operation with an HDMI-to-DVI adapter is 

not guaranteed. In addition, video signals from a PC 
are not guaranteed (page 25).

• When the “Resolution” (page 43) is set to any resolu-

tion not supported by the TV, no video is output by the 
HDMI OUT. 

• If the message “Resolution Error” appears on the AV 

receiver’s display, this indicates that your TV does not 
support the current video resolution and you need to 
select another resolution on your DVD player.

The onscreen menus don’t appear
• On European, Australian and Asian models, specify 

the TV system used in your area in the “TV Format 
Setup” on page 48.

• On your TV, make sure that the video input to which 

the AV receiver is connected is selected.

The picture is distorted
• On European, Australian and Asian models, specify 

the TV system used in your area in the “TV Format 
Setup” page 48.

The immediate display does not appear
• The immediate display will not appear when the input 

signal from the COMPONENT VIDEO IN is output to 
a device connected to the COMPONENT VIDEO 
MONITOR OUT.

• Depending on the input signal, the immediate display 

may not appear when the input signal from the HDMI 
IN is output to a device connected to the HDMI OUT.

Reception is noisy, FM stereo reception is 
noisy, or the FM STEREO indicator doesn’t 
appear
• Relocate your antenna.
• Move the AV receiver away from your TV or com-

puter.

• Listen to the station in mono (page 61).
• When listening to an AM station, operating the remote 

controller may cause noise.

• Passing cars and airplanes can cause interference.
• Concrete walls weaken radio signals.
• If nothing improves the reception, install an outdoor 

antenna.

The remote controller doesn’t work
• Make sure that the batteries are installed with the cor-

rect polarity (page 13).

• Install new batteries. Don’t mix different types of bat-

teries, or old and new batteries (page 13).

• Make sure that the remote controller is not too far 

away from the AV receiver, and that there’s no 
obstruction between the remote controller and the AV 
receiver’s remote control sensor (page 13).

• Make sure that the AV receiver is not subjected to 

direct sunshine or inverter-type fluorescent lights. 
Relocate if necessary.

• If the AV receiver is installed in a rack or cabinet with 

colored-glass doors, the remote controller may not 
work reliably when the doors are closed. 

• Make sure you’ve selected the correct remote control-

ler mode (pages 14 and 112-118).

• When using the remote controller to control other 

manufacturers’ AV components, some buttons may 
not work as expected.

• Make sure you’ve entered the correct remote control 

• Make sure to set the same ID on both the AV receiver 

and remote controller (page 95).

TX-SR707_En.book  Page 123  Tuesday, July 28, 2009  1:03 PM