ONKYO TX-SR707 Manual Do Utilizador

44

If you connect a video component to HDMI IN, you 
must assign that input to an input selector. For example, 
if you connect your DVD/BD player to HDMI IN 1, you 
must assign HDMI IN 1 to the DVD/BD input selector.
If you’ve connected your TV to the AV receiver with an 
HDMI cable, you can set the AV receiver so that 
composite video, S-Video, and component video sources 
are upconverted* and output by the HDMI OUT. You can 
set this for each input selector by selecting the “- - - - -” 
option.

Notes:
• If no video component is connected to HDMI OUT 

(even if the HDMI input is assigned), the AV receiver 
selects the video source based on the setting of 
Component Video Input.

• When an HDMI IN is assigned to an input selector, the 

AV receiver will select audio from HDMI IN as a pri-
ority.

• The TUNER input selector cannot be assigned and is 

fixed at the “- - - - -” option.

• If you connect an input component (such as UP-A1 

series Dock that seated iPod) to the UNIVERSAL 
PORT jack, you cannot assign any input to PORT 
selector.

• Do not assign the component connected with the 

HDMI input to the TV/TAPE selector when you set 
“TV Control” setting to “On” (see page 97). 
Otherwise, appropriate CEC (Consumer Electronics 
Control) operation is not guaranteed.

• This procedure can also be performed on the AV 

receiver by using its [SETUP] button, arrow buttons, 
and [ENTER] button.

Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] but-

tons to select “1. Input/Output 
Assign”, and then press 
[ENTER].
The “Input/Output Assign” menu 
appears.

q]/[w] but-

tons to select “2. HDMI Input”, 
and then press [ENTER].
The “HDMI Input” menu appears.

Composite video, S-Video, 

component video

Composite video, S-Video, 

component video

HDMI

HDMI

q]/[w] but-

e]/

r] buttons to select:

Select the HDMI IN to which 
the video component has 
been connected.

- - - - -: Output composite video, 

S-Video, and component 
video sources from the HDMI 
OUT. The video output signal 
from the HDMI OUT is the 
one configured in “Compo-
nent Video Setup” (see 
page 45).

• “AUX” is used only for input from 

the front panel jacks.

• Each HDMI IN cannot be assigned to 

more than one input selector. When 
HDMI IN have already been 
assigned, you must set first any 
unused input selectors to “- - - - -” or 
you will be unable to assign HDMI 
IN to input selector.

Press the [SETUP] button.
The setup menu closes.

TX-SR707_En.book  Page 44  Tuesday, July 28, 2009  1:03 PM