ONKYO TX-SR707 Manual Do Utilizador

58

You can temporarily mute the output of the AV receiver.

Tip:
You can specify how much the output is muted with the 
“Muting Level” setting (page 93).

With the sleep timer, you can set the AV receiver to turn 
off automatically after a specified period.

If you need to cancel the sleep timer, press the [SLEEP] 
button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver sleeps, 
press the [SLEEP] button. Note that if you press the 
[SLEEP] button while the sleep time is being displayed, 
you’ll shorten the sleep time by 10 minutes.

You can select the priority of the use of Front High 
speakers, Front Wide speakers, or SurrBack speakers.

Notes:
• If the “Speakers Type(Front)” setting is set to 

“Bi-Amp” (page 47), or Powered Zone 2 is being used 
(page 104), this setting cannot be selected.

• When the listening mode that doesn’t correspond to 

the switch of the speakers is used, the setting cannot 
be selected.

You can connect a pair of stereo headphones (1/4-inch 
phone plug) to the AV receiver’s PHONES jack for pri-
vate listening, as shown.

Notes:
• Always turn down the volume before connecting your 

headphones.

• While the headphones plug is inserted in the PHONES 

jack, the Headphone indicator and speaker/channel 
indicator FL, FR lights up. (The Powered Zone 2 
speakers are not turned off.)

• When you connect a pair of headphones, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, Pure Audio or DTS Surround Sensation.

• Listening mode automatically changes into DTS sur-

round sensation when you connect a pair of head-
phones while DTS surround sensation mode is 
currently selected.

• The following listening modes can be used with head-

phones (the listening modes available also depend on 
the currently selected input source): Stereo, Direct, 
Pure Audio, Mono and DTS Surround Sensation.

Press the [RECEIVER] button, 
and then press the [MUTING] but-
ton.
The output is muted and the MUTING 
indicator flashes on the display, as 
shown.

To unmute the AV receiver, press the 
[MUTING] button again, or adjust the 
volume.
The Mute function is cancelled when 
the AV receiver is set to Standby.

Press the [RECEIVER] button, 
and then press the [SLEEP] but-
ton repeatedly to select the 
required sleep time.
The sleep time can be set from 90 to 10 
minutes in 10 minute steps.

The SLEEP indicator appears on the 
display when the sleep timer has been 
set. The specified sleep time appears on 
the display for about five seconds, then 
the previous display reappears.

The sound from front high speakers 
is output by priority.

The sound from front wide speakers 
is output by priority.

The sound from surround back 
speakers is output by priority. 

TX-SR707_En.book  Page 58  Tuesday, July 28, 2009  1:03 PM