ONKYO TX-SR604 Manual Do Utilizador
39
First Time Setup
—Continued
2
Put the speaker setup micro-
phone at measurement point
phone at measurement point
1
.
Notes:
• Make sure the microphone is hori-
• Make sure the microphone is hori-
zontal.
• If there’s an obstacle between the
microphone and any speaker, the
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
automatic setup will not work cor-
rectly. Set up the room as you would
when enjoying a DVD.
• Positioning the microphone close to
where your ears would normally be
will provide better results. You can
adjust the height of the microphone
by using a tripod or level table.
will provide better results. You can
adjust the height of the microphone
by using a tripod or level table.
• It takes about 10 minutes to complete
the automatic speaker setup.
Connect the setup microphone
to the SETUP MIC jack.
to the SETUP MIC jack.
Notes:
• If the AV receiver was previously
• If the AV receiver was previously
muted, it will be unmuted.
• Automatic speaker setup cannot be
performed while a pair of head-
phones is connected.
phones is connected.
3
Press [ENTER].
The automatic speaker setup starts.
A test tone is output by each speaker in
turn, as the Audyssey2EQ function
determines which speakers are con-
nected. This takes a few minutes.
turn, as the Audyssey2EQ function
determines which speakers are con-
nected. This takes a few minutes.
Note:
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so don’t make
any noise.
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so don’t make
any noise.
Auto Speaker Setup
========================
Please place microphone
at center of listening
area at ear height.
========================
Please place microphone
at center of listening
area at ear height.
Push Enter:Next
Auto Speaker Setup
========================
Do not unplug Setup Mic.
========================
Do not unplug Setup Mic.
Please, keep quiet.
Now measuring...
4
The speaker detect results
appear.
appear.
“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.
detected. “No” means that no speaker
was detected.
If you agree with the results, use
the Up and Down [
the Up and Down [
]/[
] but-
tons to select Next, and then
press [ENTER].
press [ENTER].
The options are:
Next:
Next:
Proceed to the next step.
Retry:
Return to step 2 and try again.
Cancel:
Cancel the automatic speaker setup.
Auto Speaker Setup
========================
----SP Detect Result----
FL:Yes FR:Yes
SL:Yes SR:Yes
SBL:Yes SBR:Yes
C:No SW:Yes
------------------------
Next
Retry
Cancel
========================
----SP Detect Result----
FL:Yes FR:Yes
SL:Yes SR:Yes
SBL:Yes SBR:Yes
C:No SW:Yes
------------------------
Next
Retry
Cancel