ONKYO TX-NR3007 Manual Do Utilizador

62

qwer

Notes:
• If any of your speakers is 4 ohms, change 

“Speaker Impedance” setting before running 
Audyssey MultEQ XT Room Correction and 
Speaker Setup (see page 57).

• If the AV receiver is muted, it will be unmuted 

automatically when Audyssey MultEQ XT 
Room Correction and Speaker Setup starts.

• Room correction and speaker setup can only be 

used with Speakers A.

• Room correction and speaker setup cannot be 

performed while a pair of headphones is 
connected, or Speakers B is selected.

• It takes about 30 minutes to complete the room 

correction and speaker setup for eight positions. 
Total measurement time varies depending on the 
number of speakers.

• Do not disconnect the speaker setup microphone 

during the room correction and speaker setup, 
unless you want to cancel the setup.

• Do not connect or disconnect any speakers during 

the room correction and speaker setup.

Turn on the AV receiver and the 
connected TV.
On the TV, select the input to which the 
AV receiver is connected.

a (page 61), and connect it 

to the SETUP MIC jack.
The speaker setting menu appears.

If you change these settings, refer to 
step 5 on “Speaker Settings” (page 57) 
or step 4 on “Setting the Powered 
Zone 2/3” (page 134).

Notes:
• Before starting Audyssey MultEQ 

XT Room Correction and Speaker 
Setup, arrange the room and connect 
the speakers as you would for 
enjoying movies. Changes to the 
room after auto setup requires you 
run the auto setup again, as room EQ 
characteristics may have changed. 

• When starting the room correction 

and speaker setup, do not stand 
between the speakers and 
microphone, and avoid obstacles 
blocking the path between speakers 
and microphone. This will produce 
inaccurate results. 

• Position the microphone at ear height 

of a seated listener with the 
microphone tip pointed directly at 
the ceiling using a tripod. Do not 
hold the microphone in your hand 
during measurements as this will 
produce inacurate results.