ONKYO TX-SR503E Manual Do Utilizador

30

Press the [STANDBY/ON] button. 
Alternatively, press the remote controller’s [RECEIVER] button followed 
by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.

To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any 
loud surprises the next time you turn on the AV receiver, always turn down the volume 
before turning it off.

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the 
very first time. These settings only need to be made once.

■ Have you connected a component to a digital audio input?

If you have, see “Assigning Digital Inputs to Input Sources” on 
page 31.

■ Have you connected an Onkyo MD recorder or CD recorder to the TAPE IN/OUT jacks?

If you have, see “Changing the TAPE/MD/CDR Display” on 
page 31.

■ Have you connected any speakers with an impedance of between 4 and 6 ohms?

If you have, see “Minimum Speaker Impedance Setup” on page 32. 
(Not North American models.)

■ Do the speaker configuration—this is essential!

See “Speaker Configuration” on page 32.

CD recorder / MD recorder

Speaker
4

Ω – 6Ω