ONKYO TX-SR674E Manual Do Utilizador
50
Basic Operations
—Continued
The multichannel DVD input is for connecting a compo-
nent with a 7.1-channel analog audio output, such as a
DVD-Audio or SACD-capable DVD player, or an
MPEG decoder. See page 26 for hookup information.
nent with a 7.1-channel analog audio output, such as a
DVD-Audio or SACD-capable DVD player, or an
MPEG decoder. See page 26 for hookup information.
Note:
While the multichannel DVD input is selected, the
Speaker Configuration settings on page 67 are ignored,
and signals from the multichannel input are fed to the
speakers as they are.
While the multichannel DVD input is selected, the
Speaker Configuration settings on page 67 are ignored,
and signals from the multichannel input are fed to the
speakers as they are.
You can adjust the bass and treble for the front speakers,
except when the Direct or Pure Audio (not North Amer-
ican models) listening mode is selected.
except when the Direct or Pure Audio (not North Amer-
ican models) listening mode is selected.
■
Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
front speakers from –10 dB to +10 dB in 2 dB steps.
■
Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
the front speakers from –10 dB to +10 dB in 2 dB steps.
You can display various information about the current
input source as follows.
input source as follows.
Note:
This procedure can also be performed on the AV receiver
by using its [DISPLAY] button.
This procedure can also be performed on the AV receiver
by using its [DISPLAY] button.
The following information can typically be displayed for
input sources.
input sources.
* If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is
displayed for about three seconds, then the previously
displayed information reappears.
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is
displayed for about three seconds, then the previously
displayed information reappears.
Interpreting Surround Channel Values
A: The number of front channels (3 means front left,
front right, and center).
B: The number of surround channels (2 means surround
left and surround right). If there’s surround back
channel information, this will be 3.
channel information, this will be 3.
C: LFE channel for subwoofer (1 means yes).
Using the Multichannel DVD Input
Press the [RECEIVER] button,
followed by the [MULTI CH] but-
ton.
followed by the [MULTI CH] but-
ton.
The MULTI CH indicator appears on
the display.
the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
input will now be used for the DVD
input source.
Adjusting the Bass & Treble
1
Press the [TONE] button repeat-
edly to select either Bass or
Treble.
edly to select either Bass or
Treble.
2
Use the TONE [–]/[+] buttons to
adjust.
adjust.
RECEIVER
MULTI CH
MULTI CH indicator
TONE
Displaying Source Information
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
and then press the [DISPLAY]
button repeatedly to cycle
through the available informa-
tion.
RECEIVER
DISPLAY
Input source &
volume
Signal format
*
or sampling
frequency
Input source &
listening mode
A
B C