ONKYO TX-SR876 Manual Do Utilizador

68

While the automatic speaker setup is in progress, one of 
the following error messages may appear:

❑ Ambient noise is too high

This message appears if the background noise is too 
loud and the measurements cannot be performed 
properly.

Remove the source of the noise and try again.

Retry:  Return to the measured point immediately 

before and start set up again.

Cancel:  Cancel the automatic speaker setup.

❑ Speaker Detect Error

This message appears if a speaker is not detected. “Yes” 
means that a speaker was detected. “No” means that no 
speaker was detected. Check your speaker connections 
and retry, or cancel the automatic speaker setup.

The front right speaker has not been detected.

The surround right speaker has not been detected.

The surround back left speaker has not been detected.

There is a problem with the front left speaker. If the 
warning triangle (

) appears for the subwoofer, it may 

be that the output from the subwoofer is too loud.

The number of speakers detected on the second or 
third measurement was different to the number 
detected on the first measurement.

Make sure speakers that cannot be detected are con-
nected property.

Retry:  Return to step 2 and try again.

Cancel:  Cancel the automatic speaker setup.

❑ Writing Error!

This message appears if saving fails.

Try saving again. If this message appears after 2 or 3 
attempts, the AV receiver is probably malfunctioning. 
Contact your Onkyo dealer.

Retry:  Return to step 2 and try again.

Cancel:  Cancel the automatic speaker setup.