ONKYO TXNR828 Manual Do Utilizador

■

`

`

On 

This setting specifies whether or not to apply the Late 
Night processing on a Dolby TrueHD source.

• When this setting is set to “Off”, the Late Night function for 

Dolby TrueHD sources is automatically fixed to “Off”.

• When this setting is set to “Off”, the Dialogue Normalization 

information is not available for Dolby TrueHD sources.

■

`

0 to 2 to 5

The DTS Neo:6 Music listening mode creates 6-
channel surround sound from 2-channel stereo 
sources. With this setting, you can specify by how 
much the front left and right channel output is 
attenuated in order to create the center channel. 
Changing the value from “0” to “5” will spread the 
sound of the center channel to left and right 
(outwards).

■

`

–3dB to Reference to +3dB

With this setting, you can adjust the sound stage when 
using Audyssey DSX.

• This listening mode can be selected only when all the 

following conditions are satisfied: 
– The center speaker is connected.
– Either the front high or front wide speakers are connected.
– Powered Zone 2 is not in use.

■

`

Wide:

Select if the listening angle is greater than 30 
degrees.

`

Narrow:

Select if the listening angle is less than 30 
degrees.

With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of 
the front left and right speakers relative to the 
listening position. Ideally, the front left and right 
speakers should be equidistant from the listening 
position and at an angle close to one of the two 
available settings.

• For best results, we recommend setting “

” to 20° 

and “Wide” to 40°.

■

, DTS

, Multich PCM, Dolby 

`

QdB, –20dB, –10dB, or 0dB

With these settings, you can set the level of the LFE 
(Low Frequency Effects) channel individually for each 
input sources.
If you find that low-frequency effects are too loud 
when using one of these sources, change the setting 
to –20 dB or –

Q dB.

*1

Dolby Digital and Dolby Digital Plus sources 

*2

DTS and DTS-HD High Resolution sources 

*3

DSD (Super Audio CD) sources 

Items can be set individually for each input selector.
Press the input selector buttons to select an input 
source.

The tone for each speaker is set automatically by 
Audyssey MultEQ

®

 Room Correction and Speaker 

Setup. To enable the following settings, you must first 
perform the Room Correction and Speaker Setup 
(

• These technologies cannot be used when a pair of 

headphones is connected.

■

`

Off 

`

Movie:

Select this setting for movie material.
The Audyssey indicator will light.

`

Music:

Select this setting for music material.
The Audyssey indicator will light.

• When “Audyssey Quick Start” has been used for 

measurement, “Audyssey” cannot be selected.

• Audyssey equalizing does not work with DSD sources.

Front left speaker

Front right speaker

Listening angle: 30°