ONKYO TX-NR5007 Manual Do Utilizador

158

Can’t record
• On your recorder, make sure the correct input is 

selected.

• To prevent signal loops and damage to the AV 

receiver, input signals are not fed through to outputs 
with the same name (e.g., TAPE IN to TAPE OUT or 
VCR/DVR IN to VCR/DVR OUT).

• When the Pure Audio listening mode is selected, 

recording is not possible because no video signals are 
output. Select another listening mode.

There’s no sound
• Only components connected to analog inputs can be 

played in Zone 2/3.

Can’t access the server or Internet radio
• Check the network connection between the AV 

receiver and your router or switch.

• Make sure that your modem and router are properly 

connected, and make sure they are both turned on.

• Make sure the server is up and running and compatible 

with the AV receiver (page 125).

• Check the “Network Settings”(page 126).

Playback stops while listening to music files on 
the server
• Make sure your server is compatible with the AV 

receiver (page 125).

• If you download or copy large files on your computer, 

playback may be interrupted. Try closing any unused 
programs, use a more powerful computer, or use a 
dedicated server.

• If the server is serving large music files to several net-

worked devices simultaneously, the network may 
become overloaded and playback may be interrupted. 
Reduce the number of playback devices on the net-
work, upgrade your network, or use a switch instead 
of a hub.

Can’t connect to the AV receiver from a Web 
browser
• If you’re using DHCP, your router may not always 

allocate the same IP address to the AV receiver, so if 
you find that you can’t connect to a server or Internet 
radio station, recheck the AV receiver’s IP address on 
Network screen.

• Check the Network settings (page 126).

Can’t access the music files on a USB device
• Make sure the USB device is plugged in properly.
• The AV receiver supports USB devices that support 

the USB mass storage device class. However, play-
back may not be possible with some USB devices 
even if they conform to the USB mass storage device 
class.

• USB memory devices with security functions cannot 

be played.

The sound changes when I connect my 
headphones
• When a pair of headphones is connected, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, Pure Audio or DTS Surround Sensa-
tion.

The speaker distance cannot be set as required
• In some cases, corrected values suitable for home the-

ater use may be set automatically.

The display doesn’t work
• The display is turned off when the Pure Audio listen-

ing mode is selected.

How do I change the language of a multiplex 
source
• Use the “Multiplex” setting on the “Audio Adjust” 

menu to select “Main” or “Sub” (page 100).

u functions don’t work

• To use 

u, you must make an u connection and an 

analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 47).

• While Zone 2 or Zone 3 is selected, the 

u functions 

don’t work.

u

• These functions don’t work when Zone 2/3 is turned 

on.

Room Correction and Speaker Setup”, the 
measurement fails showing the message 
“Ambient noise is too high.”.
• This can be caused by any malfunction in your speaker 

unit. Check if the unit produces normal sounds.