ONKYO TX-NR5007 Manual Do Utilizador

Página de 164
33
■ “Monitor Out” Setting Set to “Both”, “Both(Main)” or “Both(Sub)”
With the “Monitor Out” setting set to “Both”, 
“Both(Main)” or “Both(Sub)” (see page 52), 
video input signals flow through the AV receiver 
as shown, with composite video, S-Video, and 
component video sources all being upconverted 
for both HDMI outputs. Use the “Both”, 
“Both(Main)” or “Both(Sub)” setting if you 
connect the AV receiver’s HDMI OUT MAIN 
and HDMI OUT SUB to your TVs.
The composite video, S-Video, and component 
video outputs pass through their respective input 
signals as they are.
Both: Video signals are output from both HDMI 
outputs at the resolution supported by both TVs. 
You cannot select “Resolution” setting. The pic-
ture adjust setting will be that for “HDMI Main”.
Both (Main): Video signals are output from both 
HDMI outputs but HDMI OUT MAIN will 
become a priority; depending on the resolution, video signals may not be output from HDMI OUT SUB.
Both (Sub): Video signals are output from both HDMI outputs but HDMI OUT SUB will become a priority; depending 
on the resolution, video signals may not be output from HDMI OUT MAIN.
Note:
The “Monitor Out” setting will be automatically switched to “Analog” (see page 52) if not connected to both outputs 
when “Both” is selected or if not connected to a priority output when “Both(Main)” or “Both(Sub)” is selected. 
■ “Monitor Out” Setting Set to “Analog”
With the “Monitor Out” setting set to “Analog” 
(see page 52), video input signals flow through 
the AV receiver as shown, with composite video 
and S-Video sources being upconverted for the 
component video output. Use this setting if you 
connect the AV receiver’s COMPONENT 
VIDEO MONITOR OUT to your TV.
Composite video is upconverted to S-Video and 
S-Video is downconverted to composite video. 
Note that these conversions only apply to the 
MONITOR OUT V and S outputs, not the 
VCR/DVR OUT V and S outputs.
The composite video, S-Video, and component 
video outputs pass through their respective input 
signals as they are.
This signal flow also applies when the “Resolu-
tion” setting is set to “Through” (see page 52).
Video Signal Flow and the Resolution Setting
When the “Monitor Out” setting is set to “Ana-
log” (see page 52), if the “Resolution” setting is 
set to anything other than “Through” (see 
page 52)
, the video signal flow will be as shown 
here, with composite video and S-Video sources 
being upconverted for the component video out-
put.
The composite video, S-Video, and component 
video outputs pass through their respective ana-
log input signals as they are. HDMI input signals 
are not output.
IN
MONITOR OUT
DVD/BD player, etc.
AV receiver
TV, projector, etc.
Composite
Composite
S-Video
S-Video
Component
Component
Video Signal Flow Chart
HDMI
HDMI
IN
MONITOR OUT
DVD/BD player, etc.
AV receiver
TV, projector, etc.
Composite
Composite
S-Video
S-Video
Component
Component
Video Signal Flow Chart
HDMI
HDMI
IN
MONITOR OUT
DVD/BD player, etc.
AV receiver
TV, projector, etc.
Composite
Composite
S-Video
S-Video
Component
Component
Video Signal Flow Chart
HDMI
HDMI