ONKYO TX-SA706 Manual Do Utilizador

97

In addition to your main listening room, you can also enjoy playback in the other room, or as we call Zone 2. And, you 
can select a different source for each room.

There are two ways you can connect Zone 2 speakers:
1. Connect them directly to the AV receiver/AV ampli-

fier.

2. Connect them to an amp in Zone 2.

This setup allows 5.1-channel playback in your main 
room and 2-channel stereo playback in Zone 2, with a 
different source in each room. This is called Powered 
Zone 2, as the Zone 2 speakers are powered by the AV 
receiver/AV amplifier. Note that when Powered Zone 2 
is turned off, you can enjoy 7.1-channel playback in your 
main room.

Hookup
• Connect your Zone 2 speakers to the AV receiver/AV 

amplifier’s ZONE 2 L/R speaker terminals.

Notes:
• With this setup, the Zone 2 volume is controlled by the 

AV receiver/AV amplifier.

• Powered Zone2 cannot be used if “Speakers Type” is 

set to “Bi-Amp” (see page 45).

This setup allows 7.1-channel playback in your main lis-
tening room and 2-channel stereo playback in Zone 2, 
with a different source in each room.

Hookup
• Use an RCA audio cable to connect the AV receiver/

AV amplifier’s ZONE 2 LINE OUT L/R jacks to an 

analog audio input on your Zone 2 amp.

• Connect your Zone 2 speakers to the speaker terminals 

on your Zone 2 amp.

Note:
The Zone 2 volume must be set on the Zone 2 amp.

When Zone 2 is turned on, the output from the 12V 
TRIGGER OUT ZONE 2 goes high (+12 volts, 100 mil-
liamperes max). Connecting this jack to a 12-volt trigger 
input on a component in Zone 2 will make that compo-
nent turn on or off as and when Zone 2 is turned on or off 
on the AV receiver/AV amplifier.

To use this setup, you must set the “Powered Zone2” 
setting to “Act” (see page 98).

TV

AV receiver/AV amplifier

TV

AV receiver/AV amplifier

Receiver/

integrated amp