ONKYO TX-NR801 Manual Do Utilizador

24

Connecting to Audio/Video Equipment—Continued

Using an RCA audio connection cable, connect the 
output jacks of the turntable to the PHONO audio jacks 
of the TX-NR801/TX-NR801E. Make sure that you 
properly connect the left channel to the L jack and the 
right channel to the R jack.

Note:
The TX-NR801/TX-NR801E is designed for use with 
moving magnet cartridges. For proper operation, con-
nect a ground (or earth) wire to the GND terminal. For 
some turntables, however, connecting the ground wire 
may cause increased noise, and in such a case, a ground 
wire is not necessary and should not be connected.

Using RCA audio connection cables, connect the output 
jacks (PLAY) of the device to the TAPE AUDIO IN 
jacks of the TX-NR801/TX-NR801E and connect the 
input jacks (REC) of the device to the TAPE AUDIO 
OUT jacks of the TX-NR801/TX-NR801E. Make sure 
that you properly connect the left channels to the L 
jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the 

DIGITAL IN COAX jack or DIGITAL IN OPT jack of 
the TX-NR801/TX-NR801E, depending on the type of 
connector on the device.

On the initial settings of the TX-NR801/TX-NR801E, 
the TAPE input source is set for digital input at the 
OPT 2 jack. 
If the digital connection is made to a different jack, this 
must be changed at Setup Menu 

→ Input Setup → 

Digital Setup (See page 36).
If the device has a digital input, connect it to the 
DIGITAL OUT OPT jack of the TX-NR801/
TX-NR801E for digital recording of the REC OUT 
signal from the TX-NR801/TX-NR801E.
However, if the same device also has a digital output and 
it has already been connected to the TX-NR801/TX-
NR801E, you cannot connect the digital input of the 
device to the DIGITAL OUT jack of the TX-NR801/TX-
NR801E simultaneously.

Note:
The output from the DIGITAL OUT jack of the 
TX-NR801/TX-NR801E is only the digital signal input 
to the DIGITAL IN jack.

The TX-NR801/TX-NR801E is equipped with AC mains 
outlets for connecting the power cords from other devices 
so that their power is supplied through the TX-NR801/
TX-NR801E. By doing this, you can leave the connected 
device turned on and have the STANDBY/ON button on 
the TX-NR801/TX-NR801E turn on and off the device 
together with the TX-NR801/TX-NR801E.

Caution:
Make sure that the total capacity of the components connected 
to the TX-NR801/TX-NR801E does not exceed the capacity 
that is printed on the rear panel (e.g., TOTAL 120W).