ONKYO TX-NR801 Manual Do Utilizador

69

In order to use the remote controller to control the 
TX-NR801/TX-NR801E from a remote location, you 
will need to prepare a multi-room kit (sold sepa-
rately) such as one of those given below:
• Onkyo’s Multi-Room System kits (IR Remote 

Controller Extension System)

• Multiroom A/V distribution and control system such 

as those from Niles

®

 and Xantech

®

If the TX-NR801/TX-NR801E is located inside a 
cabinet or other enclosure where the infrared rays from 
the remote controller cannot enter, then operation with 
the remote controller will not be possible. In such a case, 
it will be necessary to install a remote sensor at a 
location outside of the cabinet that the infrared rays from 
the controller can reach.
With this connection, select “Main” for the 
Hardware Setup 

→ Remote Setup → Position in the 

The IR IN input allows you to control the TX-NR801/
TX-NR801E from the remote zone (Zone 2) with the 
remote controller even though the remote zone may be 
on the other side of the building from the main zone. The 
diagram below shows how to make the proper 
connections for the remote zone.
With this connection, select “Zone 2” for the 
Hardware Setup 

→ Remote Setup → Position in the 

Make the connection as shown below. Do not plug in any 
equipment to the power outlet until all the connections 
are complete.

In this situation, you will need to use a commercially 
available IR emitter. Connect the mini plug of the IR 
emitter to the IR OUT terminal on the TX-NR801/
TX-NR801E and then place the IR emitter on the remote 
sensor of the component or facing it. When the IR 
emitter is connected, only the signal input to the IR IN 
terminal is output to the IR OUT terminal. The signal 
input from the remote sensor on the front of the 
TX-NR801/TX-NR801E will not be output to the IR 
OUT terminal.