ONKYO HT-R518 Manual Do Utilizador

 

41

 

7

 

For private listening, you can connect a pair of stereo 
headphones (1/4-inch phone plug) to the AV receiver’s 
PHONES jack.

 

• Always turn down the volume before connecting your 

headphones.

• While the headphones plug is inserted in the PHONES 

jack, the speakers are turned off.

• When you connect a pair of headphones, the listening 

mode is set to Stereo, unless it was already set to Pure 
Audio, Mono, Stereo, or Direct, in which case it stays 
the same.

• When the multichannel DVD input is selected, only 

the front left and front right channels can be heard in 
the headphones.

You can display various information about the current 
input source as follows.

 

• This procedure can also be performed on the AV 

receiver by using its [DISPLAY] button.

The following information can typically be displayed:

*1 When AM or FM radio is used, the band, preset num-

ber, and frequency are displayed.

*2 If the input signal is analog, or AM or FM radio is 

selected, no format information is displayed. If the 
input signal is PCM, the sampling frequency is dis-
played. If the input signal is digital but not PCM, the 
signal format is displayed. Information is displayed 
for about 3 seconds, then the previous display reap-
pears.

 

A: The number of front channels (front left, front right, 

and center).

B: The number of surround channels (surround left and 

surround right).

C: LFE channel for subwoofer (1 means yes).

ON/STANDBY

STANDBY

PURE AUDIO

CINEMA

FILTER

LATE NIGHT

PHONES

MULTI CH

PURE AUDIO

A

B C

HT-R518_En.book Page 41 Tuesday, March 11, 2008 11:31 AM