ONKYO TXNR727 Manual Do Utilizador

■

If you’re using a Web proxy, enter a proxy port 
number here.

■

`

`

Off 

This setting enables or disables control over the 
network.
When enabled, the NET indicator will be dimly-lit 
while the AV receiver is in standby mode. Note that 
the indicator may not light under certain conditions 
(

• When set to “On”, the power consumption slightly 

increases in standby mode.

■

`

Enable 

`

When this setting is enabled, you will be notified if a 
firmware update via network of high importance is 
available.

• Selecting “Never Remind me” on the notification window 

will switch this setting to “Disable” (

).

• For details on the update notification, see “Firmware 

■

This setting enables the AV receiver to pair with 
Bluetooth-enabled device.

Status
Press ENTER button to display “Now Pairing” and 
start pairing.

• If pairing setting is not set, “Ready” appears on-screen 

display. The name of the device paired with the AV receiver 
is displayed if pairing setting is set.

• For details on the Bluetooth connection, refer to the 

instruction manual of the Bluetooth-enabled device.

• The pairing can be done by holding down BLUETOOTH 

button on the AV receiver until BLUETOOTH indicator 
flashes.

• This setting cannot be selected if you’ve selected NET or 

USB as input selector in Multi Zone.

If you skipped the initial setup wizard, for example on 
first-time use, you can reaccess it from here.
See “Initial Setup” (

).

• This setting cannot be selected if the “Monitor Out” setting 

is set to “Sub”.

■

`

1, 2, or 3

When several Onkyo components are used in the 
same room, their remote ID codes may overlap. To 
differentiate the AV receiver from other components, 
you can change its remote ID from “1”, to “2” or “3”.

• If you do change the AV receiver’s remote ID, be sure to 

change the remote controller to the same ID (see below), 
otherwise, you won’t be able to control it with the remote 
controller.

See “Looking up for Remote Control Codes” 
(

With this preference, you can protect your settings by 
locking the setup menus.

■

`

`

Unlocked 

When “Locked” is selected, the setup menus will be 
locked and you cannot change any setting.

Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.