ONKYO HT-R390 Manual Do Utilizador

En

With 

u (Remote Interactive), you can use the following 

special functions:

■

System On/Auto Power On
When you start playback on a component connected via 
u, if the AV receiver is on Standby, it will 
automatically turn on and select that component as the 
input source.

■

Direct Change
When playback is started on a component connected via 
u, the AV receiver automatically selects that 
component as the input source.

■

Remote Control
You can use the AV receiver’s remote controller to 
control your other 

u-capable Onkyo components, 

pointing the remote controller at the AV receiver’s 
remote control sensor instead of the component. You 
must enter the appropriate remote control code first 
(

• Use  only 

u cables for u connections. u cables are supplied 

with Onkyo players (DVD, CD, etc.).

• Some components have two 

u jacks. You can connect either 

one to the AV receiver. The other jack is for connecting 

additional 

u-capable components.

• Connect only Onkyo components to 

u jacks. Connecting other 

manufacturer’s components may cause a malfunction.

• Some components may not support all 

u functions. Refer to 

the manuals supplied with your other Onkyo components.

See “Recording” on the recording (

page 26).

• The AV receiver must be turned on for recording. Recording is 

not possible while it’s in Standby mode.

• If you want to record directly from your TV or playback VCR to 

the recording VCR without going through the AV receiver, 
connect the TV/VCR’s audio and video outputs directly to the 
recording VCR’s audio and video inputs. See the manuals 
supplied with your TV and VCR for details.

• Video signals connected to composite video inputs can be 

recorded only via composite video outputs. If your TV/VCR is 
connected to a composite video input, the recording VCR must 
be connected to a composite video output.

• The surround sound and DSP listening modes cannot be 

recorded.

• Copy-protected Blu-ray discs and DVDs cannot be recorded.
• Sources connected to a digital input cannot be recorded. Only 

analog inputs can be recorded.

• DTS signals will be recorded as noise, so don’t attempt analog 

recording of DTS CDs or LDs.

u Components

Make sure that each Onkyo component is 
connected with an analog audio cable (connection 
D in the hookup examples) (

page 14).

u connection (see the illustration).

page 25).

e.g., CD player

e.g., DVD player

VCR, DVD recorder, 

cassette tape deck, 

CDR, MD recorder, etc.