ONKYO DTR-7.9 Manual Do Utilizador
47
For AM tuning to work properly, you must specify the
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
AM Frequency Step Setup
(not North American models)
(not North American models)
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [
q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.
Setup”, and then press [Enter].
The “Hardware Setup” menu appears.
3
Use the Up and Down [
q]/[w] but-
tons to select “3. Tuner”, and
then press [Enter].
The “Tuner” menu appears.
then press [Enter].
The “Tuner” menu appears.
4
Use the Left and Right [
e]/[r]
buttons to select:
10kHz: Select if 10 kHz steps are
used in your area.
9kHz: Select if 9 kHz steps are used
in your area.
7. Hardware
Setup
1. Remote
Control
2. Zone2
3. Tuner
4. Analog
3. Tuner
4. Analog
Multich
5. HDMI
6. Network
6. Network
7–3. Tuner
AM Frequency Step
9kHz
5
Press the [Setup] button.
The setup menu closes.
The setup menu closes.