ONKYO TX-SA705 Manual Do Utilizador

42

Connecting the AV Receiver/AV Amplifier—Continued

■ iPod with video

Connect your RI Dock’s analog audio output jacks 
and Video output jack to the AV receiver/AV ampli-
fier’s GAME/TV IN L/R jacks and GAME/TV IN V 
jack. (Onkyo DS-A2 hookup shown below.)

■ iPod without video

Connect your RI Dock’s analog audio output jacks to 
the AV receiver/AV amplifier’s TAPE IN L/R jacks. 
(Onkyo DS-A2 hookup shown below.)

■ If you have an Onkyo DS-A1 RI Dock
• Connect its video output jack to the AV receiver/AV amplifier’s GAME/TV IN S jack.
• Enter the appropriate remote control code before using the AV receiver/AV amplifier’s remote controllers for the first 

time (see page 104).

The AV receiver has AC outlets on its rear panel that can 
be used to connect the power cords of other components 
that you intend to use with the AV receiver. These com-
ponents can then be left turned on so that they turn on 
and off as and when the AV receiver is set to On or 
Standby.
Caution:
• Make sure that the total capacity of the components 

that you connect to the AC OUTLETS does not 
exceed the stated capacity (e.g., TOTAL 120 W).

Notes:
• Onkyo components connected via 

 should be con-

nected directly to a wall outlet, not an AC OUTLET 
on the AV receiver.

• The number of AC OUTLETS, socket type, and total 

capacity depends on the country in which you pur-
chased the AV receiver.

Notes:
• Connect the Remote Interactive Dock with an 

 cable (see page 43).

• Set the Remote Interactive Dock’s RI MODE switch to HDD or HDD/DOCK.

• Set the AV receiver/AV amplifier’s input display to DOCK (see page 50).

• Refer to the Remote Interactive Dock’s instruction manual.

European model

North American model