ONKYO TX-SA705 Manual Do Utilizador
46
First Time Setup—Continued
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms (not North American models).
If you’ve connected your front speakers to the FRONT
SPEAKERS and SURR BACK SPEAKERS terminal
posts for bi-amping, you must change the Speakers Type
setting. For hookup information, see “Bi-amping the
Front Speakers” on page 24.
less than 6, set the minimum speaker impedance to 4
ohms (not North American models).
If you’ve connected your front speakers to the FRONT
SPEAKERS and SURR BACK SPEAKERS terminal
posts for bi-amping, you must change the Speakers Type
setting. For hookup information, see “Bi-amping the
Front Speakers” on page 24.
Notes:
• When bi-amping is used, the AV receiver/AV ampli-
• When bi-amping is used, the AV receiver/AV ampli-
fier is able to drive up to 5.1 speakers in the main
room.
room.
• Before you change these settings, turn down the vol-
ume.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
Speaker Settings
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
followed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
]/[
]
buttons to select “2. Speaker
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
Setup,” and then press [ENTER].
The Speaker Setup menu appears.
3
Use the Up and Down [
]/[
]
buttons to select “1. Speaker Set-
tings,” and then press [ENTER].
The Speaker Settings menu appears.
tings,” and then press [ENTER].
The Speaker Settings menu appears.
If you change these settings, you must run the auto-
matic speaker setup again (see page 54).
matic speaker setup again (see page 54).
ENTER
ENTER
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
ENTER
ENTER
2–1. Speaker Settings
Speaker Impedance
6 ohms
Speakers Type
Normal
4
Use the Up and Down [
]/[
]
buttons to select “Speaker
Impedance,” and then use the
Left and Right [
Impedance,” and then use the
Left and Right [
]/[
] buttons to
select:
4 ohms: Select if the impedance of any
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
16 ohms.
5
Use the Up and Down [
]/[
]
buttons to select “Speakers
Type,” and then use the Left and
Right [
Type,” and then use the Left and
Right [
]/[
] buttons to select:
Normal: Select this if you’ve con-
nected your front speakers
normally.
normally.
Bi-Amp:Select this if you’ve con-
nected your front speakers for
bi-amped operation.
bi-amped operation.
6
Press the [SETUP] button.
The Setup menu closes.
The Setup menu closes.
ENTER
ENTER
ENTER
ENTER