ONKYO TX-SA705 Manual Do Utilizador

61

Basic Operations—Continued

You can adjust the brightness of the display.

You can temporarily mute the output of the AV receiver/

AV amplifier.

Tip:
You can specify how much the output is muted with the 
Muting Level setting (see page 92).

With the sleep timer, you can set the AV receiver/AV 
amplifier to turn off automatically after a specified 
period.

If you need to cancel the sleep timer, press the [SLEEP] 
button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver/AV 
amplifier sleeps, press the [SLEEP] button. Note that if 
you press the [SLEEP] button while the sleep time is 
being displayed, you’ll shorten the sleep time by 10 min-
utes.

You can connect a pair of stereo headphones (1/4-inch 
phone plug) to the AV receiver/AV amplifier’s PHONES 
jack for private listening, as shown.

Notes:
• Always turn down the volume before connecting your 

headphones.

• The speakers are turned off while the headphones plug 

is inserted in the PHONES jack (Zone 2 speakers are 
not turned off).

• When you connect a pair of headphones, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio.

• Only the Stereo, Direct, Pure Audio, and Mono listen-

ing modes can be used with headphones (the listening 
modes available also depend on the currently selected 
input source).

• When the multichannel input is used, only the front 

left and right audio can be heard in the headphones.

• To adjust the headphone level, press the [CH SEL] 

button on the remote controller, and then press the 
[LEVEL +]/[LEVEL -] buttons. You can adjust the 
level between –12 dB and +12 dB.

Press the [RECEIVER] button, 
and then press the [DIMMER] 
button repeatedly to select: 
• Normal + VOLUME light on.
• Normal + VOLUME light off.
• Dim + VOLUME light off.
• Dimmer + VOLUME light off.
Alternatively, you can use the AV 
receiver/AV amplifier’s [DIMMER] 
button (not European models).

Press the [RECEIVER] button, 
and then press the [MUTING] but-
ton.
The output is muted and the MUTING 
indicator flashes on the display, as 
shown.

To unmute the AV receiver/AV ampli-
fier, press the [MUTING] button again, 
or adjust the volume.
The Mute function is cancelled when 
the AV receiver/AV amplifier is set to 
Standby.

Press the [RECEIVER] button, 
and then press the [SLEEP] but-
ton repeatedly to select the 
required sleep time.
The sleep time can be set from 90 to 10 
minutes in 10 minute steps.

The SLEEP indicator appears on the 
display when the sleep timer has been 
set. The specified sleep time appears on 
the display for about five seconds, then 
the previous display reappears.